2004 bmw x5 4.4L engine leaking oil around a component on the left front of engine. What is in this area that could be leaking oil?
SOURCE: High oil Consumption, BMW M5
Look for Castrol TWS 10W60 Motor Oil. This car should not burn so much oil, you need to use a different kind. It is recommended by BMW as well. I also heard the VANOS isnt an issue anymore, can be fixed with a different MAFF. Good luck!
SOURCE: 1994 BMW 840 CI oil leak
No it will NOT work, get a second opinion on that leak that's way too high for that job. Good luck and thanks for using FIX YA
SOURCE: Engine Oil Leak
try this website to see if they be able to help you its www.alldatadiy.com if it was me i would go to autozone or any part store and pickup a dry to go in the oil and that way you be able to find the leak easier hope i was able to help you Michigan Man
SOURCE: how to replace left front window regulator(driver
Hi,
It depends on how old your car is and the availability of spare parts in your area. The problem might be that the plastic rollers have mal-aligned on the rail thus causing the metal arm to bend. You will need to replace the engine set for the winder. I recommend you get the specific type for the model you are using to avoid future recurrences.
Cheers
SOURCE: fuse box diagram for a 2004 BMW 325ci
Fuses & RelaysThe fuse box is located under the engine hood on the left side, near the upper strut housing or near the battery.
Various relays are also mounted on the fuse box for easy accessibility.
Flashers
The flashers are located behind the bottom center of the lower instrument trim panel.
Review the...
- BMW E36 Fuse Box Relay Layout
- 325ci Owners Manual
Hope helped.
E60 Removing And Installing, Sealing Or Replacing Oil Sump (M54)
Necessary preliminary tasks. -
- Remove intake filter housing
- Remove guide tube for oil dipstick
- Lowering front axle support
- Drain off engine oil
- Disconnect plug connection to oil level sensor.
On vehicles with automatic transmission:
- Detach oil lines from automatic transmission and from oil pan.
- Unfasten oil pan screws at transmission and engine ends.
- Lower and remove oil pan.
Installation:
Sealing faces clean and free of seal debris.
Apply approx.3 mm wide, 2 mm high coat of Drei Bond 1209 sealing agen to the area around seams.
Installation:
Or take it to a dealer....
164 views
Usually answered in minutes!
×