1993 jeep yj speedometer replacement - 1993 Jeep Wrangler

Mike Butler

• 6674 Answers
• Posted on Jan 07, 2009

SOURCE: Jeep Wrangler YJ : difficult to close doors when cold weather

Have you tried spraying WD-40 in behind and all around , work it, then spray with lithium grease?

SOURCE: Speedometer on 1992 Jeep Wrangler YJ not working.

The sensor for the speedometer is in the tailshaft of the transmission its called a vss vehicle speed sensor,all you have to do is unplug the plug and unthread it and replace.

Josh Canaday

• 444 Answers
• Posted on Mar 14, 2012

SOURCE: how to step by step guide on replacing starter in 1993 ford jeep wrangler yj 4x4

well im not sure that the Ford part is.. but on your YJ its pretty simple, 1.disconnect the battery 2,disconnect the power leads to the cylanoid (its mounted to the top side of the started) 3.remove the starter mount bolts and slide the started our of the transmission Note: sometimes its necessary to remove the mount bolts and and remove the starter from the transmission in order to gain good access to the power wires. you can either have a partner hold the starter for you once its loose or use a bungee cord to tie it up while you disconnect it. 4. installation is reverse or removal Note: on re-manufactured starters it may be necessary to shim the starter. if after installation it grinds on the flywheel then you know it needs to be shimmed, most re-mans will come with a set of shims. hope this helps, and for the record most men who think they know alot about cars or talk like they do dont know jack diddly. i know a couple women who are fantastic mechanics.

SOURCE: 1993 jeep wrangler yj speedometer and odometer do not work

first check your fuses, then if thay are fine and veh has a veh speed sensor vss, it may have a bad connection, or the sensor may be bad, (located on the transmission)

SOURCE: i have a 1993 jeep yj put a new fule pump in it lots of gas in fule rail turns over dost start can aneyone help

If the injectors do not fire, fuel in the rail does not matter since it's not getting gas into the engine. Look to see if your check engine light comes on, when you turn on the ignition. If it does not, then your ecu computer is in need of repair since it's not sending either a spark or fuel injector signal to fire up your jeep.