Question about 2004 Ford F-350 Super Duty

Open Question

4 wheel drive not disenguage - 2004 Ford F-350 Super Duty

Posted by Anonymous on

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I just bought a 1985 F350 1 ton truck, it has a hydraulic clutch. The clutch disenguages fine when the truck is warm, but when I drive it 30 miles and every thing heats up the clutch does not disenguage


I'm sure you've checked the fluid level, I would first try bleeding the system to rule out any air pockets. It also could be a fluid bypass situation, especially if the master/slave are old or the cup seals have been exposed to contaminated fluid. The seals can become hardened over time and will not expand along with their respective bore when hot. The cure for that is replacement of the clutch master cylinder and/or slave. The master cylinder is a fairly easy task, but the slave cylinder requires removal of the transmission. Bleeding this system can be frustrating, but you should be able to find plenty of information about the process around the web. Good luck.

Oct 30, 2014 | 1985 Ford F350

1 Answer

How far does the slave cylinder on a 99 ram 2500 diesel have to travel to disenguage the clutch?


might just need bleeding through more , check for any leaks etc on all connections,pipes etc

Jun 02, 2017 | Dodge Ram 2500 Cars & Trucks

1 Answer

Replaced battery cables on my 1998 Ford Expedition. Now when I turn the ignition the starter enguages then emediatly disenguages, like there is a load on it other than turning over the motor. Was star


You said you replaced the battery cables, how come? Problems getting car started? might be a bad starter, not cables... if battery is good, cables are new, may be starter solenoid malfunction... the solenoid tells the starter gear to engage the flywheel, then release the flywheel once the engine rotates fast enough (assuming you let go of the key once engine gets going :)... or you could even have a worn ignition switch or faulty wire behind the switch (not so likely)

Sep 04, 2012 | Cars & Trucks

1 Answer

1998 s10 v6 4 wheel drive will not disenguage


check your transfer case switch on top of your transfer case.they get stuck sometimes.

Feb 06, 2011 | 1998 Chevrolet S-10 Pickup

1 Answer

I have a 2000 Grand Jeep Cherokee. It always starts fine from home but sometimes when I am out and have left the car in a parking lot, the steering column is locked, usually upside down or sideways, when...


Make sure you park with the wheels straight. Sometimes the steering lock is real tough to disenguage if the wheel is shut off with it not straight. This vehicle is particularly tough at times. Next time you're in this jam, you should be able to yank on the wheel in one direction or the other and it will free up the ignition to turn on.

Jan 24, 2011 | Jeep Grand Cherokee Cars & Trucks

1 Answer

My 2001 Chevy tahoe indicator light reads service 4wd. What do I do?


IF THIS IS THE FIRST TIME THIS LIGHT HAS EVER COME ON, AND YOU HAVENT BEEN PUTTING THE 4WD UNDER ANY STRESS, IT MAY JUST BE A LOW FLUID LVL IN THE TRANSNFER CASE. IF FLUID LVL IS FINE THEN THE SENSOR THAT SCREWS INTO THE TRANSFER CASE HAS TAKEN A DUMP, REPLACE, AND THE LIGHT SHOULD GO OUT AFTER THE ENGINE RUNS A CYCLE. MAKE SURE THAT THE 4WD ISNT PARTIALY ENGUAGED, PUT THE TRUCK IN 4WD AND DRIVE A FEW BLOCKS THEN STOP DISENGUAGE AND SEE IF THAT WORKS..

Sep 04, 2010 | 2001 Chevrolet Tahoe

1 Answer

I used my 4 wheel drive today on my 2001 Nissan Fronteir. After I took it out of 4 wheel drive I headed down the road. I heard a constant noise so I slowed and put it back in 4 hi. The noise stopped but...


that would be the lock for the front axle not disenguaging all the way. it used to be you should do like you did put in reverse, then move forward. look in owners manuel it may be a normal condition.

Jun 06, 2010 | 2001 Nissan Frontier Crew Cab

1 Answer

I have a 99 mazda B3000 2 wheel drive the abs light came on and the speedometer starting acting up where it won't work until I reach 40mph. is it the speed/abs sensor in the back axle


vice versa.. speedometer started acting up and caused the abs system to disenguage... eratic speedo replace the vss....vehicle speed sensor on transmission

Sep 03, 2009 | 2007 Mazda B3000

1 Answer

1999 Chevy 4wd silverado 5.3l


I had the same issue with my truck, the switch was the problem.

I solved my issue by process of elimination which started with the switch,,, easiest thing to replace first.

Feb 05, 2009 | 1986 Chevrolet S-10 Blazer

Not finding what you are looking for?
2004 Ford F-350 Super Duty Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...