Question about 1990 Chevrolet K2500

Open Question

Flasher relay location

Hazard/emergency flasher relay

Posted by Anonymous on

Ad

5 Related Answers

Anonymous

  • 337 Answers

SOURCE: locating the turn signal flasher on 1993 corsica

The turn signal flasher is mounted in a clip on the right side of the steering column support bracket. The hazard flasher is located in the component center, under the instrument panel, on the right side. Replace the flasher by unplugging the old one and plugging in the new one.

Posted on Dec 03, 2008

Ad

Anonymous

  • 194 Answers

SOURCE: Directionals Don't work on 99 Cavalier

under the dash below the steering wheel it is probly blue and round located on one of the courners of the fues box

Posted on Dec 05, 2008

Ad

Anonymous

  • 4 Answers

SOURCE: 1997 Chevy Tahoe both turn signals stopped working

Sounds like the flasher unit to me. Normally the emergency flasher and turn signal are separate.

Posted on Jul 21, 2009

Frank Ferree

  • 335 Answers

SOURCE: 2000 Chevrolet 2500 hazard flasher location. Is

hello. the hazard flasher is the same as the turn flasher. it is mounted behind the left ip fuse block.


9b682fe.gif

Posted on Jun 19, 2010

alicantecoli

Colin Stickland

  • 22485 Answers

SOURCE: my turn signals went out

they both use the same flasher ,try changing the hazard light switch as they do go wrong and then the flashers stop working

Posted on Jan 05, 2011

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Emergency flasher switch


The Hazard Warning flasher switch is located in the center of the instrument panel above the radio. Press the switch to turn on the Hazard Warning flasher. When the switch is activated, all directional turn signals will flash on and off to warn oncoming traffic of an emergency. Press the switch a second time to turn off the Hazard Warning flasher. This is an emergency warning system and should not be used when the vehicle is in motion. Use it when your vehicle is disabled and is creating a safety hazard for other motorists. When you must leave the vehicle to seek assistance, the Hazard Warning flasher will continue to operate even though the ignition switch is OFF. NOTE: With extended use, the Hazard Warning flasher may wear down your battery. http://cdn.dealereprocess.com/cdn/servicemanuals/chrysler/2010-townandcountry.pdf

Nov 26, 2015 | 2010 Chrysler Town and Country

1 Answer

The turn signals do not flash the light6s are all good the emergency flashers work atm times what is the problem


Some vehicles have separate flasher relays for hazards and turn signals. Sounds like yours' does. So most likely your problem is a bad turn signal relay.

So locate your relay cluster (check owners manual), locate the turn signal relay, remove the old one and plug in the new. It's just socketed and you can't install the wrong way.

Good luck.

Mar 21, 2015 | Cars & Trucks

2 Answers

Where is my emergency flasher relay switch on my 1995 grand marquis


Should be two flasher units in fuse block, one for turn signals, one for hazard 4 ways.

Jan 23, 2015 | 1995 Mercury Grand Marquis

2 Answers

Where is the emergency flasher relay located on 2013 Rogue?


Here is what the service manual says. Looks like it is not a flasher relay but a function of the body control module.

TURN SIGNAL AND HAZARD WARNING LAMP SYSTEMSystem Description OUTLINE Turn signal lamp and the hazard warning lamp is controlled by combination switch reading function and the flasher control function of BCM.
TURN SIGNAL LAMP OPERATION - BCM detects the combination switch condition by the combination switch reading function. - BCM supplies voltage to the right (left) turn signal lamp circuit when the ignition switch is turned ON and the turn signal switch is in the right (left) position. BCM blinks the turn signal lamp.
HAZARD WARNING LAMP OPERATION BCM supplies voltage to both turn signal lamp circuit when the hazard switch is turned ON. BCM blinks the hazard warning lamp.
TURN SIGNAL INDICATOR LAMP AND TURN SIGNAL SOUND OPERATION - BCM transmits the turn indicator signal to the combination meter with CAN communication while the turn signal lamp and the hazard warning lamp are operating. - Combination meter outputs the turn signal sound with the integrated buzzer while blinking the turn signal indicator lamp according to the turn indicator signal.
HIGH FLASHER OPERATION (FAIL-SAFE) - BCM detects the turn signal lamp circuit status by the terminal current value. - BCM increases the turn signal lamp blinking speed if the bulb or harness open is detected with the turn signal lamp operating. NOTE: The blinking speed is normal while operating the hazard warning lamp.

Oct 13, 2014 | 2013 Nissan Rogue

1 Answer

Turn signal flasher relay location in


Normally, yes.The flasher should be in the fusebox - turn on the signal and get your ear close to the fusebox - you should hear the flasher clicking. There should be 2 flashers there - 1 for the turn sigs and the other for the hazard/emergency flashers.

Jan 25, 2014 | GMC Sierra 1500 Cars & Trucks

1 Answer

Emergency flasher dont work on 1994 chevy 2500


Sounds like the flasher relay is bad. There is a separate one for the turn signals and hazards. Below is a diagram of its location. It kind of looks backwards but just look where the arrow is pointing to the front of the vehicle. I hope this helps...

12_25_2011_5_31_30_pm.jpg

Dec 25, 2011 | 1994 Chevrolet C/K 2500

2 Answers

Where is the fan relay located on a 98 Chevrolet camaro?


there are three of them(assuming coolant fan) and they are located in the under hood electrical center. Left(dr) front corner of engine compartment.

Nov 18, 2011 | 1998 Chevrolet Camaro

1 Answer

Ok a friend gave me a 1996 toyota 4 runner the turn signals only work when u do them maualy rigth or left i CANNOT find the emergency flasher switch location neither ive replaced the flasher relays and the...


Yes your right the emergency flasher switch is the flasher and located in the middle of the dash and it has a triangle on it with a point up and a ! in the middle. It's dark red in color and when depressed lights up red and flashes ( if it's working like it's supposed to ) If the fuse for hazard is blown the flasker won't work on turn singal either. The fuse for the hazard is hot all the time and the turn fuse is only on with the key. You might find that when you find the button and push i thaqt the turn signals work normally and after you find why the flashers doesn't work on hazard then the hazards will work too.
with the hazard switch poped out of the dash ( it just pries out) it'll have lot's of wires one will be hot all the time and another will become hot when you turn the key on. the other wires go to the turn signal switch. If you find that the switch works fine and it still does flash on turn but it does flash on hazard with it on as a hazard go around and look at all of the lights. They have to work on both the frontand the back and the indicators in the cluster ( speedometer head ) If they all work and are bright ( not dim light the running light) The hazard switch is bad as it's the flasher is made into it.

Nov 30, 2010 | Toyota 4Runner Cars & Trucks

1 Answer

The Turn signals on my 1998 Toyota Corolla will not work they won't even show up on dashboard what is the problem?


Do the flashers still work? This sounds like a bad flasher relay problem.Locate the flasher for the turn signals and hazard lights. The flasher relay is under the dash near the steering column. It will be the larger of the square relays.Try wiggling it to see if turn siganls will work or emergency flashers will work. The relay should look like this jsmes1027.jpg

Nov 10, 2010 | 1998 Toyota Corolla

2 Answers

2000 camry turn signals and emergency not working - fuses OK.


if the Hazard does not work as well i would start there and then move on to the flasher relay under the steering column

Apr 30, 2009 | 2000 Toyota Camry Solara

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...