Where to find Flasher relay - 1995 Mitsubishi Montero

These days, it is a function of the BCM.

What's the 2012 Nissan Rogue turn signal relay location?

https://www.vehiclehistory.com > questions > whats-the...
3 answers
The 2012 Nissan Rogues turn signal relay, which is referred to as a flasher in some parts of the world, is housed firmly within the cars dashboard. https://forums.nicoclub.com/flasher-relay-location-t386148.html

https://www.google.com/search?q=2016+Nissan+Rogue+SV.+Where+is+the+flasher+relay+unit

if you google Where is flasher relay located on 1999 Chevrolet Silverado 1500 you will find answers.
Look above the fuse box under the left side of the dash to locate the flasher unit. The flasher is a square unit that looks like a relay. It will have its own receptacle mounted separately from the fuse box.

Flasher in front of your right knee under dash.
press the helpful button
check the links

96 04 Mustang Raxiom Modified Turn Signal Flasher Install Excludes 99 04...

Turn Signal flasher relay location

Mustang Modified Flasher Install

http://forums.corral.net/forums/general-mustang-tech/14393-blinker-relay-where.html

The Combination Flasher, also referred to as the combo-flasher, is mounted to the in-line bracket which is located to the right of the Junction Block. The flasher can be removed by pulling in a rearward direction. The left under panel silencer duct must be removed to access the flasher. The combo-flasher is black in color for ease of identification.
The Turn Signal and Hazard Warning Flasher is combined into one unit called a Combination Flasher (Combo-Flasher). The combo-flasher controls the flashing of the hazard warning system and the turn signal system. An inoperative bulb or incomplete turn signal circuit will result in an increase in flasher speed.

Ref: http://www.10w40.com/questions/auto-repair-questions/where-is-the-flasher-relay-on-a-2000-chrysler-concorde
Good Luck

More than likely the electronic turn signal flasher is defective.
Instructions

1. Remove the Old Flasher Relay
   • Using your socket wrench, disconnect the negative cable from the car's battery terminal. The negative terminal and cable are identified on the top of the battery using the minus ("--") symbol. Once the cable is disconnected, wrap the metal end completely with the black electrical tape. Lay the cable down and make sure it's not touching any metal surfaces.
     
   • 2Open the driver side front door and kneel or position yourself so that you're able to see under the dashboard.
     

   
   

   • 3Locate the automotive flasher relay under the dashboard on the right-hand side. The flasher relay is about the same size as an ice cube. It will be held in place by one screw and will have a three-pronged wiring harness connected to it.
     
   • 4Remove the screw holding the flasher relay in place and slowly lower it from underneath the dashboard.
     
   • 5Hold the flasher relay in one hand, and with the other hand gently disconnect the wiring harness plug from the relay. Never separate the flasher relay by pulling the harness off by the wires, always hold the plastic harness plug itself.
     
   Install the New Flasher Relay
   • 6Inspect the new flasher relay to make sure it isn't damaged. Hold the new flasher relay and the old one side by side and compare them, ensuring that they are exactly the same.
     
   • 7Carefully plug the wiring harness connector into the new flasher relay. Make sure no other wires are intertwined as you raise the flasher and harness back into position under the dashboard.
     
   • 8Secure the flasher relay by returning its mounting screw.
     
   • 9Unwrap the negative battery cable's connector and reattach it to the car's battery terminal. Turn the power on or start your car and test out the new flasher relay to make sure it's working properly
     

you may have a bad flasher relay. its also known as a hazard relay, or turn signal flasher.

There is a multi-function switch in the steering column which controls the flasher module.The flasher module is located in the back of the glove compartment. In the flasher module there are Three relays.They are behind a piece of plastic labeled "Relay Access" You will need to use a screwdriver to pry the bottom tabs of the plastic to pull it out. You will see three small black cubes. Those are your flasher relays. You can get those relays at any car part store. Thanks.

There is one flasher that controls all 4 turn signals. If only one light is not flashing the flasher relay is not the problem. If the flasher relay is bad none of them will flash. Check the bulb. The Turn signal flasher relay is located front seating area. It is integral to the hazard switch located in the center of the instrument panel, just above the radio. Curtorsey: Auto Zone

Your Olds has 2 flasher relays. One for the turn signals and one for the hazard lights.
The turn signal flasher relay is located on the driver's side, under the dash, mounted on the steering column.
The hazard flasher relay is located driver's side, under dash, driver's side of steering column, mounted on fuse panel.

If you have the Owners Manual for the car look up flasher and it will show you a diagram of the relays so that you know what you're looking for. I own a 1992 Chrysler New Yorker Fifth Avenue and the flasher relay is located right above your glove box on the passenger side. You have to unscrew the glovebox casing with a phillips screw driver. Once you have this unscrewed there are your fuses and two sets of relays. One relay set that you can see on the right side (this is not where the flasher relay is) and one that is up more in the dash and closer to the inside part of the car by the side of the air condition controls. This is where the flasher relay is located. You can slide the whole casing of relays up off of the metal hook that it is held on by, and then pull it down and out so that it is easier to work on. There should be two square relays and two circle relays. When holding the case of relays, the two square relays are on the left and the two circle relays are on the right, it will be the top right circle relay that is the flasher relay. This took me forever to find. I hope this helps all of you so that you don't have to rip your dash apart like I did.