SOURCE: 1995 cutlass supreme transmission
It physically will fit and bolt up,but there are many different ratio,and drive and driven sprocket tooth counts,different final drive ratios,all monitored by the computer with electronic speed sensors.If the trans from the 95 has a different ratio than the 93,the computer will set gear ratio error codes,and possibly put the trans in a failsafe mode,stuck in 2nd or 3rd gear.On the transmission case,down by where the passenger side axle would go in,is a thin metallic tag,maybe 2"x 3",and it has bar codes,and also a series of numbers and letters.The numbers and letters,large cap,are the final drive gear ratio code.They should match on the two transmissions in question.
SOURCE: replacing oil pump in 95 Cutlass 3.1L
YOU WILL HAVE TO REMOVE THE EXHAUST PIPE IN THE REAR.IT HITS THE FLOOR PAN.ALSO REMOVE THE TWO DOG BONE MOUNTS ON TOP IF THIS ONE HAS THEM
SOURCE: My 1992 Cutlass Supreme SL Olds failed emissions.
High NOX readings indicate a somewhat lean condition IE: hot exhaust. Possible causes are cracked and leaking vacuum lines or lazy oxygen sensors. If possible have a reputable garage with engine electronics scanner services check the sensor to see if its helping to create the lean condition
SOURCE: falls dead when driving, will restart after awhile
Did you try checking or replacing the coolant sensor? I think you should replace it along with the thermostat. Are there any problems like sputtering or any unusual noises or symptoms? Smoke, anything?
SOURCE: 94 cutlass supreme is overheating,all fluids are
Over heating can be caused by a faulty thermostat and or weak water pump and dirty radiator and old antifreeze or the radiator fan now working when at idle but should not over heat when driving. Service the cooling system if it has never been serviced before. Replace the thermostat, buy some radiator flush to clean out the radiator and heater core. Just follow the instruction and replace the antifreeze and make sure it's a 50/50 mix water/antifreeze. If you not sure how to mix it 50/50 you can buy them 50/50 premixed. Water boils at 100'C so you need antifreeze mixed with it but antifreeze does not have the same heat transfer as water so you cannot run 100% antifreeze cause it does not transfer heat fast enough and you over heat. Good luck and hope this helps. Keep me posted, Be glad to help, once you service the cooling system and your still over heating, then we look at the water pump.
54 views
Usually answered in minutes!
×