Question about 1991 Jeep Wrangler

1 Answer

Why is my steering sticking when im driven down the road after putting a 3inch body on it it wasnt doin it before

My jeep is not steering good drive down the road after I put a 3inch body lift on it idont have power steerin on it

Posted by Anonymous on


1 Answer

Andrew Smart

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Expert
  • 230 Answers

Steering linkage is binding,was there an extension provided with the kit?

Posted on Apr 03, 2015


5 Related Answers


  • 1 Answer

SOURCE: 2001 jeep grand cherokee overheating

is the radiator fan coming on and staying on, or not coming on at all?? i was having the same problem, and it turned out to be a fan relay switch which was pretty easy to replace. around 40 bucks, and maybe 30-45 mins.

Posted on Jan 25, 2009


Benjamin Walton

  • 27 Answers

SOURCE: Transmission sticking

most people say no to a high mileage transmission flush if it hasnt been done before on the vehicle, I say if it starts to slip then flush it but if it is just sticking whop the old lucas trans mission oil to her! they have it at advanced it should free up those sticky valves! but if you havnt flushed it before now i would'nt
it is believed that over time your transmission fluid gets "gritty" from the clutches wearing , and over time your transmission becomes reliant on that grit to run "smoothly" I've done it and it came out fine but that was due to slipping from thin or burnt transmission fluid,
I would really try an additive to free up the valves before i'd do a flush!

Posted on May 26, 2009


  • 12 Answers

SOURCE: 2005 jeep shimmy

hey, kinda late but, I would check the track bar. With engine running, have someone turn steering wheel back and forth (quarter turns are fine). watch the frame side (should be passenger side for right side drive) for up and down movement. If any is noticed, replace it.

Posted on Jul 10, 2009


  • 1 Answer

SOURCE: Shaking Stering Wheel in a 2006 Jeep

I have a 2006 Jeep Wrangler and have been having this problem since I bought it used. I don't have a lift but we have tried everything. The shaking only happens on our when we excelerate or decelerate in the 45 - 50 MPH range. We have gone round and round with the dealership and they are telling us it is the tires we have on it.. and they say that if we replace them it will be ok. We are about to do that and hopefully it helps.

Posted on Jan 15, 2010


  • 2926 Answers

SOURCE: My 2000 Jeep Grand cherokee has death wobble. As i

Is it possible that one stabilizer shock is not enough to stabilize the front end????

Posted on Jan 22, 2010

Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2007 jeep liberty stuck in 4wl, handle moves down but still in 4wl drive

how'd it get there?
driving on hard pavement will in fact get it stuck,
are you on ice or dirt. ?
if on pavement, it will stick on all part time 4wd cars.
its not AWD, so can not be driven on hard pavement.
only ice,snow, dirt.
if on hard pavement move to the dirt side of road and it will now release. this is called windup, and will damage the drive line.
if you keep doing this.

Jan 21, 2014 | 2002 Jeep Grand Cherokee

1 Answer

Just replaced inner tie rod and now when start driving it ma;es an ugly sound and pulls hard to right where i got it replaced. Only going 20 mph .cant drive it... Jeep compass 2007. could itbe that it...

the inner tierod may have been put on wrong, but after any steering system parts have been replaced or fixed. it is a good idea to get it relined this is why it pulls so hard. wheels are not in alignment with each other. get it aligned, and all should be ok. if you leave it. it will wear tire down to nothing, really quick. good-dayt !

Feb 19, 2012 | 2007 Jeep Compass Limited

1 Answer

How do i replace heater blend doors on 1996 jeep grand cherokee

I haven't done one on a 96 before, but have on a 2000, while they are different body styles i assume they are very similar. On the 2000 it required removing the entire dashboard, center console and steering column. Evacuating the A/C system and draining the coolant. And finally removing and disassembling the HVAC box. While your in there take a good look at the heater core and Evaporator as they are somewhat common leak points in their corresponding systems. Won't want to put it all back together to find out a few months down the road that the evaporator is leaking.

Jan 12, 2010 | Jeep Grand Cherokee Cars & Trucks

1 Answer

What is the service interval for repacking front axle bearings on a Jeep CJ 7?

It depends on how much you drive it and how it is driven. If the vehicle is driven to and from work only, the bearings are good for a couple of years if you are using good bearing grease. If the vehicle is driven to and from work with some mild off roading, then repacking the bearing every Spring would be recommended. If you are driving this through mud and water that is deep enough for the axles to be submerged, then every time this happens, the bearings should be repacked. Hope this helps.

Nov 04, 2009 | 1983 Jeep CJ7

2 Answers

Vehicle hakes when driving 45 to 50 miles per hour

Check wheel balance,
check steering linkages for loosness - such as tie rod ends, steering rack linkages etc,
check driveline for worn/loose joints and bearings.

Jul 07, 2009 | 1996 Jeep Grand Cherokee

2 Answers

The steering wheel keeps "migrating" counter-clockwise and the ability to turn left is decreasing while ability to turn right is increasing....

Likely there's a sticking valve in the steering unit...try changing oil, or steering box will need to be replaced or serviced (rebuilt) I've used lucas conditioner with some success on these. (depends on how bad it is...sometimes takes a few days to work though)

Apr 12, 2009 | 1997 Jeep Cherokee

1 Answer

Dies at idle,fluctuating idle in neutral and park,

it sounds like your alternator is havin problems it might not be puttin out enough juice at idle to keep everything workin make sure you clean all the connections you can to

Nov 04, 2008 | 2004 Ford F150

Not finding what you are looking for?
1991 Jeep Wrangler Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides