2006 chevy colorado dip stick

SOURCE: How do I reset the "Oil Change Warning Indication" on colorado

if you have a owners manual read it. try coloradofans.com website and search the forums. i think johnny5846 is right if you don't have a DIC (driver info center). i believe you use the DIC(tripodometer). i don't know the sequence off hand, you can also you can change your lock settings and alarm settings, etc. with the DIC.

SOURCE: oil coming out of dip stick and valve cover breather

Exesive CrankCase Pressure, Check PCV Probably Cloged

Greg Bernett

• 2993 Answers
• Posted on Sep 03, 2009

SOURCE: how do i change out the knock sensor on a 2006 chevy colorado

You didn't list your engine size so please pick the applicable to your motor size:

Removal & Installation 2.8L & 2.9L Engines To Remove:

1. Lift the vehicle high enough to gain access to the knock sensor (KS) through the left front wheelhouse.
2. Remove the left front wheel and wheelhouse liner.

1. Disconnect the knock sensor (KS) connector.
2. Detach the knock sensor (KS) from the engine block.

1. Attach the knock sensor (KS) to the engine block.
   • Tighten the bolt to 18 ft lbs (25 Nm).
2. Connect the knock sensor (KS) connector.
3. Install the left front wheelhouse liner and wheel.
4. Fully lower the vehicle.

SOURCE: where would i find the transmission dip stick for

The dipstick is on the very front, near the front pan. There is a bolt, and after that the dipstick can be pulled up.

SOURCE: fuel in oil on 2002 chevy 2500hd duramax

THE DURAMAX ENGINE INJECTORS GO BAD AND SPRAY TO MUCH DIESEL AND IT FILLS THE CRANK CASE UP 200 THOUSAND MILE WARRANTY COMMON PROBLEM DON'T DRIVE IT ANY MORE IF U HAVE BAD INJECTORS.