Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Jun 20, 2014

What does the ground wire from the alternator of a 1985 ford F-150 3/4 ton truck connect

5 Related Answers

Anonymous

  • 625 Answers
  • Posted on Aug 23, 2008

SOURCE: truck stalls

have you replace the crank sensor? or cranshaft sensor?
if not do it, but before you do that make sure to have the truck inspect for a posible aftermarket alarm installed if it does have it remove and drive it for a few days,
and please after trying leave ranking or feedback for me, thanx and good luck

Ad

Curt Downs

  • 1779 Answers
  • Posted on Dec 07, 2008

SOURCE: I need a wiring diagram

ok carmona, go to autozone website, enter your f-250 info, click on vehicle repair guide, then chasis electrical, then wiring diagram. Let me know if u have any trouble accessing the info. Good luck!

RJones1125

Rick Jones

  • 373 Answers
  • Posted on Feb 22, 2009

SOURCE: 1985 Ford F-150

if engine won't crack - dead battery
if engine cranks but won't start - no fuel or spark
fuel reservoir is the fuel tank.
a fuel filter can be inside a housing...

Anonymous

  • 11896 Answers
  • Posted on Jul 20, 2009

SOURCE: I need a wiring diagram for the solenoid switch on

f17-03.gif.
Here is your diagram. You can go to autozone.com, register there for free, then view a full free online repair manual for your vehicles.

Anonymous

  • 1 Answer
  • Posted on Aug 05, 2009

SOURCE: 1981 ford truck alternator schematic

replace an alternator on a 1981 ford f-150

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

1985 toyota 1 ton pickup, covered ground next to coil?

If it were a ground, it wouldn't have been covered in a plastic box. The post that held it was insulated from the cab. Do not try to ground it again, you may burn your truck to the ground.
0helpful
1answer

I cant figure out how to wire a push button ignition on my 1985 ford f-150

If you're looking for wiring a push-button starter, then you just need to connect one terminal of a momentary type switch to the solenoid (little) post on your starter, and the other wire to a ground source. This will only crank the engine, so you would need an additional switch, or the actual ignition switch to switch on the accessories, and the ignition system.
1helpful
1answer

Replaced alternator on 1985 Ford Bonco 4X4 302 engine, made sure the new one was tested at the store before bringing it home. Will not produce charge to battery. There are 5 posts on the back of the...

turn your vehicle on, disconnect the battery, both terminals(while truck is still on) if it dies on you, then either the alternator is bad or wiring is wrong. if it stays on, then you may have a bad battery or voltage regulator. Check the voltage on the battery before you turn it on(should be from 11.5v-12v), when you turn it on if the alternator if working properly you should have around 13v-14v.
1helpful
2answers

1998 F-150 xlt triton v8 has new

make sure all the wires were connected back to the battery there is a red wire that sits by itself and when you disconnect the battery it tends to fall also check the alternator circuit breaker could be blown.
1helpful
2answers

1981 ford truck alternator schematic

replace an alternator on a 1981 ford f-150
0helpful
1answer

Charging alternater wire gets hot and archs

yep the regulator is stuck open replace it
0helpful
1answer

Wireing from alternator to siliniod

one is a ground wire usually black one is positive usually red and the third goes to the voltage regulator
Not finding what you are looking for?

81 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...