P0507 code check engine light stays on with the code po507

PO507 is a idle code and the PO882 is a low input to the sensor. From all my research it shows a loss of voltage from the battery I suggest you have the battery test loaded and checked for a bad battery Good Luck hop this works Mike L.

Extracted from Engine-Codes.com

Code P0507

Possible causes

- Dirty throttle body

- Electric throttle control actuator misadjusted or damaged

- Faulty Electric throttle control actuator

- Intake air leak

- Poor electrical connection to the Intake Air Control (IAC) valve


What does this mean?

Tech notes

If there are no intake leaks, clean throttle body, adjust engine idle and erase engine code. If the code comes back you may have to replaced the Electric Throttle Control Actuator (Motor) to repair the problem.



There is a factory service bulletin for the following Chevrolet models:



2006-2008 Chevrolet Trail Blazer

2007-2008 Chevrolet Avalanche

2007-2008 Chevrolet Express

2007-2008 Chevrolet Silverado

2007-2008 Chevrolet Suburban

2007-2008 Chevrolet Tahoe

Chevrolet Factory Service Bulletin OBDII Code P0507


What does this mean?

When is the code detected?

Thi P0507 code sets when the Powertrain Control Module (PCM) detects an engine speed outside of the Idle Air Control (IAC) valve range of control.

Possible symptoms

- Engine Light ON (or Service Engine Soon Warning Light)

- Engine hard to start

- Rough or erratic idle speed

P0507 Chevrolet Description

The Idle Air Control (IAC) valve is a Powertrain Control Module (PCM) controlled stepper motor located on the throttle body. The stepper motor drives a valve pintle which protrudes into a passage that bypasses the throttle plates. The PCM commands the IAC valve pintle to extend to decrease the idle speed. The bypass air flow is reduced and the idle speed decreases as the pintle approaches its seat. The PCM retracts the IAC valve pintle away from its seat to increase the idle speed. The retracting of the IAC valve pintle allows more air to bypass the throttle plates. One of the PCMs uses for the IAC system is to maintain a desired idle speed. This DTC sets when the PCM detects an engine speed outside of the IAC\'s range of control.





Read more: http://engine-codes.com/p0507_chevrolet.html#ixzz3ObdI2chF

Here's code P0128.Here's code P0463.Here's code P0507.I would check Code P0507 first.it may cause the other 2 to go off.

The P0507 means Idle Control System RPM Higher Than Expected

car diagnostic scanner

You haven't had a Tune-Up in 25 years

You may have gotten new spark plugs
That is called Preventative Maintenance

PO457---EVAP Control System Leak Detected
(Fuel Filler Cap Loose)

PO507---Idle Air Control System RPM highter than expected
Sloppy work on the part of whomever does your repairs

Check for Vacuum Leaks from Air Filter Cover, & ducting
to Throttle Body

Doubt the Air Idle Control is the issue

P0507 - Idle Air Control System RPM Higher Than Expected

Could be vacuum leak, dirty throttle body, faulty IAC

po 300 is random/ multible cylinder misfire detected po507 idle system rpm high-- go to this site for the po507 meaning--www.obd-codes.com/p507 === please go to this site for the po300 code---- www.obd-codes.com/p0300

Random/Multiple Cylinder Misfire Detected have a good day !!

po507 idle rpm higher than expected.idle control valve? po304 cyl 4 misfire.catalyst damage. should repair. looked it up in manual.good luck.

po102--maf sensor, could be a bad air cleaner and not letting air into engine, po122--tps pedal position sensor low, replace or adjust tps sensor,or wiring,po507--idle control system high input. for this you can take off idle air control, and clean out carbon from were it mounts on engine. it is just before throttle body at end of air intake hose, it is black. do not push on pintle on end of valve when cleaning, use a old toothbrush to clean carbon off of valve, use carb cleaner but do not soak valve in liquid of any kind. good luck!!