Question about 2007 Lexus RX 400h Hybrid

Open Question

Rx 400h VSC

VCS check light reset pls, many tnx. ;)

Posted by Anonymous on

Ad

5 Related Answers

gfischer21

George Fischer

  • 236 Answers

SOURCE: My 2001 Lexus LS430 was misfiring, riding rough,VSC light is on

go to auto zone, advanced autoparts, or a certified mechanic and ask if they can reset the codes, it should be free

Posted on Jun 17, 2009

Ad

Anonymous

  • 185 Answers

SOURCE: 2000 Lexus RX 300 - VSC Light comes on and brake pulsation

you most likely have an "air gap" or "tone ring" problem with one of your sensors or tone rings. i would suggest letting a technician diagnos which problem it is, as it is a diagnosis that requires some experience.

Posted on Oct 25, 2009

Ad

Anonymous

  • 430 Answers

SOURCE: just got car service for 75,000 miles also had new

Sounds to me like someone has perhaps knocked the ABS sensor while working on the brakes. The ECU in these cars interlinks various stability and braking components. Go back to the service center and ask them to put a code reader on the car and get a read out. It may only require that they reset the fault codes, but do not delay. On some Lexus vehicles these lights will also come on when the battery has been disconnected and there will be a reset for the programs, but the TRAC off light has never come on on my 2001 when doing brakes or battery swap.
nice find an 02 with 75,000. My 2001 is over 160

Posted on Nov 19, 2009

01fordeb

Chris Busby

  • 1033 Answers

SOURCE: vsc light on my lexus rx 350 2007 .

I'm not sure about the Lexus, but Nissan and other vehicles with the VSC usually will be on until you can drive on a straight road for approximately 2-3 miles without stops and about the same speed during the reset process. The interstate or some type of hwy will reset this light once the vehicle has learned the Vehicle Stabilization Control in which is learned by the way you drive and enables the car to have stable control. Hope this helps out, if this doesn't work, I would take it in for more diagnostics.

Posted on Jul 16, 2010

Kelly

  • 224 Answers

SOURCE: Is it OK to drive

Yes you can still drive it, and having the o2 sensor replaced should fix the problem.

Posted on Jun 27, 2011

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vcs/vcsoff /lightsdo not go off


VSC is a system that helps prevent side skids and help stabilize the vehicle while turning on a curve. Is the Check Engine Light on also? (picture of an engine). If the check engine light is on then have someone fix that first because if there is a fault in the engine controls then your vehicle will turn off the VSC system automatically. If no Check Engine Light then either a re-calibration by a repair shop, a bad part in the VSC or the switch is turned off.

Feb 13, 2015 | 2001 Lexus Gs 300

1 Answer

2003 Lexus GS300 P0031 code


Yes the O2 sensor preheater problem will turn on the VSC light, see the complaint often, why? don't know
.P0031 TOYOTA - Oxygen Sensor Heater Control Circuit Low Bank 1 Sensor 1
In most cases the O2 being replaced cures the code but here is the full story.
Possible causes- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit open shorted to ground
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit poor electrical connection
- Faulty Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit fuse
- Faulty Engine Control Module (ECM)

Jun 16, 2012 | 2003 Lexus Gs 300

1 Answer

How do I reset the maintenance msg on a 2007 Lexus RX 400H?


push odo buttom and keep pressing ,turn ing key on w/o start engine few seconds

Aug 10, 2010 | 2007 Lexus RX 400h Hybrid

1 Answer

I have 2007 rx 350 lexus and the vsc ligt on ,what it means , just change tire is it because of that and about 3 weeks ago just fixed the break also. pls help thanks,


Look down below your mileage reset button, around by your gas door release button and there is s VSC button. Push it and the light goes off. It is also in your owner's manual.

Jul 18, 2010 | 2007 Lexus RX 350 FWD

1 Answer

Vsc light on my lexus rx 350 2007 .


I'm not sure about the Lexus, but Nissan and other vehicles with the VSC usually will be on until you can drive on a straight road for approximately 2-3 miles without stops and about the same speed during the reset process. The interstate or some type of hwy will reset this light once the vehicle has learned the Vehicle Stabilization Control in which is learned by the way you drive and enables the car to have stable control. Hope this helps out, if this doesn't work, I would take it in for more diagnostics.

Jul 16, 2010 | 2007 Lexus RX 350 FWD

1 Answer

What causes a toyota highlander VCS warning


When your VSC (Vehicle Stability Control) light comes on, it means your car has been forced to take evasive action to avoid a dangerous situation. For example, if you're driving on an icy or wet, slippery road, and take a turn too sharp or accelerate too quickly, the vehicle will automatically reduce acceleration or apply pressure to the brakes to prevent the car from losing control. In this situation the VSC indicator light will light up to alert you that the action was taken, and remind you to slow down - or to be extra careful. Be safe!

Jan 18, 2010 | 2005 Toyota Highlander

2 Answers

2002 toyota 4runner with the engine,vsc off,vsc trac lights on


NEED TO HAVE COMPUTER CHECK FIND WHAT CODE MADE THE ENGINE KLIGHT COME ON.. AND HAVE IT FIXED,, VSC LIGHTS COME ON BECAUSE THE COMPUTER DEACTIVATES THE VSC AS A SAFETY FEATURE WHEN CK ENGINE LIGHT IS ON

Jul 30, 2009 | 2002 Toyota 4Runner

3 Answers

My 2007 Toyota Tundra 4.7l shows VSC OFF lights


check air filter for dirty , how many miles or kms have your car? , maybe need to replace spark plugs, try to reset the ecu for a momentany malfunction, remove the negative battery terminal few minutes and reconnect,start engine and drive, check if lights goes off , please write me

Jul 04, 2009 | 2007 Toyota Tundra

1 Answer

I removed the brake pads (to check out thickness) and replaced them. Now I am getting the brake, ABS, and VSC warning lights and have no brakes. Any ideas, suggestions?


have the dealer run a test on the system and see what trouble codes show up, that will tell u where to look for the problem, it makes no sense why you have no brakes, so this test is essential.

Jun 16, 2009 | 2007 Lexus RX 400h Hybrid

Not finding what you are looking for?
2007 Lexus RX 400h Hybrid Logo

Related Topics:

285 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Mike

Level 3 Expert

4372 Answers

Brad Brown

Level 3 Expert

18563 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...