How to programme new subaru remote fob on 2000 model impreza turbo

SOURCE: I bought a Subaru Impreza STI 2009 model .. What kind of the oil used in this car and is it Syntihtic oil?

yeah, i use royal purple, 5w-30 on my 05. i lose a fair amount of oil (2 big turbos). and also txcs99, are you sure it's the same motor? i thought they upgraded a little

Marvin

• 85242 Answers
• Posted on Apr 10, 2009

SOURCE: how do u clean the coolant temperature sensor on a

it is in the thermostat housing. Do you have any system trouble codes

SOURCE: 2008 Subaru Impreza RS Central Locking

The red light on the dash has several blinking patterns, just depending on what you set if for. But no matter what setting (valet mode or armed mode) the key fob should still work for the doors. If the unlock is not working, but the lock is working your problem is in the remote. If you open it up you will find that the rubber peice that makes contact with the board is broken. The remotes will need to be replaced, which is covered under the factory wrty. If the lock and unlock does not work at all then there is a programming issue, the dealer can reprogram the remotes for you. The reprogramming has to be done by the dealer. they have to hook up a lap top and program the remotes. The older models could be done easily.

SOURCE: I have a 1999 Subaru Impreza- Remote locking

First, it may seem obvious, but check the fuses associated with the remote unlock. Next, go to Autozone or somewhere like that where they have a remote tester. That will tell if the remote is functional. If the remote works and the fuses are good, see if you can find out how to program remotes to it. It may have forgotten the code for that remote.

Testimonial: "Thanks for the tips, i'll do some investigation.. I'm amazed at the quick reponse! "

SOURCE: Hi, I have an imported 2004 Subaru Impreza WRX.

first unlock car manually with key remove driver side kick panel/lower A pillar trim connect locking registration wires together(two white connectors,black wire and black and blue wire)press and hold central locking switch on drivers door in the unlock position .interior lamp will flash and an acoustic sound will be heard. now get your key and press unlock and then lock the door should lock then unlock, job done ,i persume it was to program the fob to work the central locking u wanted