SOURCE: 2005 Jeep Grand Cherokee (HEMI) Service Electric Brake System
Problem is a faulty Steering Angle Sensor (part of Steering Module) located in steering column ...replacement part $600.00.
SOURCE: 1999 jeep grand cherokee abs light has come on.what to do?
actually it could be something as simple as low on brake fluid. check this and then check to make sure you do not have worn brake pads on the tires this can also set a code when one tire stops quicker than the other
SOURCE: 2002 jeep power windows and door locks stopped
SOUNDS LIKE YOU HAVE BROKEN WIRES BETWEEN DRIVER'S DOOR AND BODY AT A PILLAR..PULL RUBBER BOOT FROM BODY AND DOOR AND INSPECT WIRING HERE
SOURCE: 99 Jeep Grand Cherokee Brake light problem
You can adjust the switch by putting your thumbs on either side of the switch plunger and pushing toward the brake lever. The switch shaft will ratchet into the new position which is will then be depressed by the brake lever when it is the brake is not being depressed.
SOURCE: shift indicator light 1999 Jeep Grand Cherokee
There are two parts to it, a voltage resistor, and the EL panel itself.
You need to remove the console first. There are 2 screws under the front rubber pad, two under the cup holder, two in the bin. Remove those six first, take the storage bin out, then slide the rear cupholder out, remove the two screws under the cup holder, and one in front of it.
There are a total of 6 flat screws, and 3 self tapping screws you have removed.
Put the parking brake on, shift the tranny to N, and the transfer case to the middle position if equipped.
Remove the entire console. Slide the shifter beezel as far up vertically as you can. There are 4 clips you ned to remove to do it.
You will see a blue and black wire running into the back. Follow those wires to the resistor. You will see a transparent EL panel attatched to the resistor by two clips.
Usually, one or both of these clips has come loose, causing the light to work intermittantly. Clip them back on, and turn on the headlights to confirm that the light works correctly now.
Re-install everything in the opposite order.
383 views
Usually answered in minutes!
×