Question about Cars & Trucks
I really need more info such as...Mileage,did you do the job yourself,if so was the slave cylinder and or clutch master cylinder changed and did you bleed the system..?...So I will explain without knowing,,...Before a clutch wears completely out we find ourselves constantly working the clutch pedal stressing all clutch system components..In most cases I have looked closely and found slave cylinder and clutch master cylinder leaking ..however the slave cylinder can wear out without leaking..Most importantly the fluid itself wears out every 15 to 20,000 miles.. You don't notice but the fluid gets thousands of tiny air bubbles in it and makes the clutch weak and spongy..(Same with brakes)..You should always bleed system with an assistant just as you would a brake system..,This alone will cause the problem you are experiencing...If you already know that and you have bled the clutch system then you know the slave cylinder is at fault..(UNLESS THERE WAS SOME TYPE OF MISALIGNMENT WITH RELEASE BEARING....YOU SHOULD ALWAYS CHANGE RELEASE BEARING WITH FORK WHEN DOING A CLUTCH SERVICE..)...I assume you did...I would inspect for leaks..,Bleed it again if no leaks...If that don't help and no leaks are found change slave cylinder and or master cylinder.....I hope this helps........Brooks/Metalpoet.......
Posted on Jun 13, 2014
Bent the clutch plate when instaling . the gear box ,you can,t let the gearbox weight hang on the drive plate. Make sure the clutch plate is fitted the correct way round centre springs face towards the pressure plate .
Posted on Mar 24, 2016
i think that is a anti theft system for your car
to start you have to push the cruise button
other system are wired on the defrost to start car
if the car run ok it is just a anti theft system
Posted on Jul 16, 2009
Difficult to describe, but I will give it a try.
Inside the driver's side fender, close to the front of the car, there is a bracket that is held in place by one bolt, but which has a short horizontal bar as part of it which has two large clips encircling two cylinderical devices which have wires clipped into them at the bottoms. The one closest to the front (radiator) is the compressor clutch relay. The other one is the condenser fan relay.
Hope this helps you find it.
Posted on Oct 20, 2009
As a response to solution #1 these cars do have an overdrive while in D-4, mine was shifting in and out at 70 mph until it finally quit and the rpm is now 3100 at 70 mph insted of 2700. The car still shifts 4 full times just not the fifth-OD. I still can't find out what fixes this problem either.
Posted on Mar 19, 2010
Tips for a great answer:
Jul 24, 2018 | Honda Cars & Trucks
Mar 15, 2015 | 1993 Honda Accord
Jun 28, 2014 | Cars & Trucks
Nov 08, 2013 | Cars & Trucks
Oct 03, 2013 | 1990 Honda Accord
Nov 06, 2011 | 1998 Honda Civic
Jul 30, 2011 | 1997 Honda Accord
Nov 27, 2017 | 1997 Honda Accord
Sep 24, 2009 | 1995 Honda Accord
Jan 22, 2009 | 1993 Honda Accord
Aug 12, 2020 | Toyota Cars & Trucks
255 people viewed this question
Usually answered in minutes!