What is gage light? - 2006 Chevrolet Express

Oil sending switch needs replaced.

Check your oil level and antifreeze level or change your oil if the problem continues

I'd wager that the fuse that controls the gauges is shot, or one of the internal connectors got unplugged (Fuse sounds more likely). Radio, Lights, and Turn Lamps are usually on seperate circuits.

Have either autozone or auto discount...depending on your location, they will check it for free an tell you what the problem is.. they can reset it..however it will continue to come on until the problem is resovled

I have a 1998 chevrolet k1500 check gauge light keeps comming on and off then the tack ans speedo dose not work and truck pulls out in 3rd gear

CHECK GAGES light (1) indicates a potential engine failure(low oil pressure, low coolant, coolant overheating) has occurred.
· Check gages and shut down engine. Gages should read as follows: Oil pressure 5 to 10 psi (34 to 69 kPa) at idle; Water Temp gage below 230 degrees (110 C).
· Check engine oil level (Para 2-11) if OIL PRESS gage indicates low reading. Check coolant level (Para 2-11) if Water Temp gage indicates high reading. Notify Unit Maintenance if levels are low.

If CHECK ENGINE light (2) is on, check engine oil pressure gage (3) and water temperature gage (4). If both indicate normal, proceed with mission and then notify Unit Maintenance. If either one does not indicate normal, stop engine immediately and notify Unit Maintenance

Have you checked the fuses? Look in the owner's manual for the locations... you might have just blown one.

replace the gages their malfunctioning ,check the wires for they are grounded.

clean throttle body...make sure disconnect battery first

A "check gage light" typically indicates a faulty reading on one of the gages located on your instrument cluster. After starting your vehicle, observe your instrument cluster if one of the indicator needles on the instrument cluster remains all the way to the left or "pegs" out all the way to the right, it may be the cause of your fault. The exception is the coolant temperature gage it will take 10 to 15 minutes after which the needle should rise to a normal position. Correcting the "faulty gage light" will depend on which gage is malfunctioning. Once you have figured out which gage is causing the check gage light to illuminate, then we can proceed to correcting the problem causing it.