SOURCE: wiring diagram
Try this link http://autozone.com/servlet/UiBroker?ForwardPage=/az/cds/en_us/0900823d/80/15/3e/8f/0900823d80153e8f.jsp
SOURCE: 1996 Jeep grand Cherokee Larado, rear door stuck
go throu licence plate pannel pull up on bar and on the inside under ur pannel the nut fell off the mechanism so just put on a new nut
SOURCE: Rear Axle Seal Replacement
remove rear tires, then remove brake calipers and rotors, then remove the 4 nuts (each side) that hold the axle shafts to the axle tube (located around the axle tube behind the backing plate) then using a slide hammer pull the axle shafts out, next using a die grinder and an air hammer get he retainer collar and the bearing off (without damaging the axle shaft) then remove the seal and the outer race which will still be in the housing. next put it all back together, make sure the plate with the studs is still on then slide the seal, bearing, then retainer on (all new parts) and using a press push them all the way back on. then is simple reassembly.
SOURCE: rear door will not open
Review this reference documents: ZJ-Secc-8P-Power-Door-Locks (Page 4)
Good luck... and rated my help!!!
SOURCE: Changing spark plug wires on 2001 Jeep Grand cherokee
yah direct ignition coil pack does away for the need a a distributer cap and rotor.much higher energy ignition system where the computer tell when to fire.if that helps.not hard to change.as long as you change them one at a time so you don't screw up the order.
225 views
Usually answered in minutes!
×