Question about 1992 Geo Tracker

1 Answer

Replace ignotion switch on 95 geo trackker - 1992 Geo Tracker

Posted by Anonymous on


1 Answer

Alan Lane

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 2 Answers

1.Remove steering wheel cover from screws in bottom
2. pop off horn cover should snap off
3. Unplug three plugs to switch assembly
4. Remove steering wheel nut pull steering wheel may need puller
5. unbolt switch assembly from ignition bracket about three bolts
6. remove switch assembly and lay to side
7. mark ignition bracket vertically and horizontally
9. remove two tamper proof bolts with chizel
10. unplug ignition switch and remove to bolts from rear of ignition switch and remove switch. installation is reverse of removal.

Posted on Jun 10, 2014


Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What wires do I touch together to start a 95 Geo Tracker ignition switch going out

well there are 2 wires, like seen on "THE TERMINATOR"
one is ignition, and other is cranking.
its covered here , under how to do the hot wire. tests.
of starter. (we use a tool called a remote button)

the wiring is here.
page 1
see the center switch here, this is IGN
black-blue power feed, must go hot.

the new switch is here.
you will need new antitheft bolts,(or switch to generic),1995,tracker,1.6l+l4,1142266,electrical-switch+&+relay,ignition+starter+switch,4700

May 21, 2016 | Geo Cars & Trucks

1 Answer

How to replace heater blower switch on a 95 geo tracker

the whole truth, even better than alldata dot com.

Jan 21, 2013 | 1995 Geo Tracker

1 Answer

95 geo metro 3cyl. 1.0L no spark changed

Pull one or two sparkplugs and check them for moisture; not fuel, but for water beads.
I don't know how long your engine ran after losing coolant but there is a chance that you lost the head gasket and have gotten water into the cylinders.

Nov 26, 2009 | 1992 Geo Tracker

1 Answer

High-beams not working

U are going to have to replace the mulitfunction switch if the bulbs are not the problem

Nov 16, 2008 | 1995 Geo Metro

1 Answer

95 geo prizm steering problem

I just had this very same problem a couple of weeks ago on a '95 Prism. I had the ignition switch replaced. That has solved the issue to this point.

Jul 02, 2008 | 1995 Geo Prizm

Not finding what you are looking for?
1992 Geo Tracker Logo

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides