Question about 1988 Toyota Corolla 4 Door
Posted by Anonymous on
I can get you a diagram on monday but it goes from the alternator to the power steering pump then around the tensioner pulley then around the crank pulley then to the a/c compressor then pull on the tensioner to give you some slack and slip it on the waterpump.I hope that helps.Let me know if you still need the diagram
Posted on Nov 29, 2008
It is similar to my rear wheel drive two door.
The main vacuum line from a vacuum source on the intake goes to the multi-hose valve on the top and the distributor vacuum advance.This multi-valve switching valve is the main connection to the other vacuum hoses on mine. Two lines come in from a vacuum source and thre go out to three components according to tempature. On mine the middle one off to side 1)goes to choke opener and switching vacumm valves mounted on the fenders the other middle one 2)second from top goes to another choke opener and EGR Valve and EGRModulator. The bottom hose connection is on when cold 3)and goes to a part on the carburator to help it run better when warming up a AAP valve.
There is a check valve diaprham thing inline to the EGR vlave on the second line from top.
I have another vacuum line on the drivers side of the carburator that has a check vlave inline but larger it goes to the throttle linkage to help slow the closing of the trottle on rapid deceleration.
Posted on May 27, 2009
Tighten in several passes to 44 foot pounds.
I just wanted to add. Since this is an aluminum cylinder head, I hope you loosened the head in the loosening torque pattern. The pattern opposite of the torque tightening pattern. If not, you stand the chance of warping the head.
Again, since it's an aluminum head, it needs to be checked for flatness. Most aluminum heads need to be surfaced before re-installing.
Tightening torque pattern is as follows:
1.The Drivers side of the engine is the Left side.
From the Front going towards the back; the bolts are numbered 10, 6, 1, 3, and 7.
From the Front going towards the back on the Passenger side; the bolts are numbered 8, 4, 2, 5, and 9.
The Exhaust and Intake Camshaft Bearing Cap bolts go to 9 foot pounds. Tighten gradually. One bolt to the other with so many foot pounds, work back, and forth up to 9lbs.
Camshaft Timing Pulley bolts go to 43 foot pounds. (In a tightening sequence, and gradually)
Posted on Jul 25, 2009
Tips for a great answer:
Apr 26, 2016 | Toyota Cars & Trucks
Apr 26, 2016 | 1987 Toyota Corolla 2 Door
Fig. 2: Firing order- 4A-C engine (other A-series similar)
Mar 07, 2011 | 1983 Toyota Corolla Deluxe
Apr 11, 2010 | 1991 Toyota Corolla
Mar 15, 2009 | 1987 Toyota Corolla 2 Door
Jul 19, 2008 | 1987 Toyota Corolla 2 Door
987 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: