Question about 1998 Isuzu Trooper
Posted by Anonymous on
Go to my profile I have just explained how to change a cv boot on a Trooper. The axle needs to be taken out to change the boot so the same solution. What you call an axle I have refered to as a drive (short for driveshaft) It takes a lot of explaining so save me a lot of writing if you read the solution I gave for changing the CV boot. Cheer's
Posted on Sep 28, 2009
Under the rubber boot inside the CV joint is a big spring clip round the edge , take this out and then the shaft pulls away from the axle with the CV on it .If you are fitting a new boot cut the old off if not just get the clips off and pull the boot back.
Did you take the shaft out from the wheel hub end too ?
Posted on Oct 08, 2009
You must remove the axle from the transmission in a straight out line from the case of the transmission in a quick and very hard snapping motion, a large heavy cast iron pipe wrench works well, but remember the axle can't be at an angle, it must be straight out within a few degrees.
Posted on Apr 27, 2012
Tips for a great answer:
Oct 12, 2014 | 1997 Honda Accord
Mar 21, 2014 | 1997 Mazda 626
Apr 27, 2012 | 2001 Isuzu Trooper
May 14, 2011 | Mitsubishi Eclipse Spyder Cars & Trucks
Apr 19, 2010 | 1999 Chevrolet Silverado 1500
Mar 26, 2010 | 2002 Buick Century
Oct 04, 2009 | 1988 Isuzu Trooper 2 Door
Sep 27, 2009 | 1998 Isuzu Trooper
Jan 13, 2009 | 1994 Mazda MPV
May 24, 2014 | 1998 Isuzu Trooper
44 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: