Question about 2005 Nissan Almera 1.5

Open Question

I put 1 new headlamp on almeria 1.6 2005 it worked for 3months and now only the parks and brigths lights are working. the bulb is fine what could be the problem

When i pull out the connecting wires an put it back it works for a short while an goes off

Posted by Anonymous on

Ad

5 Related Answers

Anonymous

  • 153 Answers

SOURCE: 1990 Nissan Maxima brake lights

Almost has to be the brake switch on the brake petal.I can't think of anything else since the signals work.

Posted on Sep 24, 2008

Ad

Anonymous

  • 8 Answers

SOURCE: nissan march driver side park light and tail light problem

check the fuses- some car makes uses individual fuses per side. Just saw that in a mitsubishi- I believe Nissan does that too. Those fuses are probably under your hood.

Posted on Nov 21, 2008

Ad

super_guy

  • 1986 Answers

SOURCE: 2005 Pathfinder no reverse lights

On the side of your transmission will be a switch with several wires coming out of it. This is your reverse switch that turns on your reverse lights and most likely needs to be replaced

Posted on Oct 01, 2009

pops296

Mike Tillman

  • 174 Answers

SOURCE: Parking lights on Nissan Frontier on - trailer

First check the fuses. There may be one for trailer running lights. Check also power at the harness. If the brake lights and turn signals are seperate, there has to be a converter from 5 to 4 wire. For the power to feed back to the brake lights it sounds like the vehicle wiring is direct and not using a converter... or one of the bulbs on the trailer is contacting both contacts. Try http://www.etrailer.com/faq-wiring.aspx and maybe get a simple 4 pin tester that plugs into the 4 pin connecter. Hope this helps.

Posted on Jan 29, 2010

bayyagg

Bayyagg

  • 1672 Answers

SOURCE: Nissan maximal 2005 both tail lights went out at

Did u check the ground wire for the tail light?

Posted on Dec 02, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is tha fuse located for tha license plate light on 2005 cadillac cts and what number os it..


are the bulbs good ? Do the tail light's , park light's work ? These light's all come on when you turn the headlamp switch on to park lamps or headlamps .

Turn ON the park lamps.
Observe the license lamps.
Do the license lamps operate properly? Yes - No
No ? Go to Step 3
Do the park lamps operate properly? Yes - No
Yes - Go to Step 4

Remove the inoperative license lamp bulb.
Connect a test lamp between the instrument panel lamp fuse supply voltage 1 circuit of the inoperative license lamp bulb and the ground circuit of the inoperative license lamp bulb.
Turn ON the ignition, with the engine OFF.
Turn ON the park lamps.
Did the test lamp illuminate?

DIMMING FUSE 10 amp - located in the under hood fuse box .

Oct 02, 2018 | Cadillac Cars & Trucks

1 Answer

Replace marker light


Removal Procedure
  1. Open the hood.
  2. Remove the headlamp. Refer to Headlamp Bulb Replacement .
  3. Rotate the bulb and socket counterclockwise in order to remove the bulb and socket from the housing. Remove the side marker bulb (3) or turn signal/park bulb (4) from the socket.

Oct 01, 2015 | 2005 GMC Envoy

1 Answer

HID Headlamp flickers and then shuts off withing a few seconds after coming on.


Sounds like the head light is defective or the driver for the light. Normally both are replaced.

May 02, 2014 | 2005 BMW 330Ci Cabriolet

1 Answer

2005 Pontiac Grand Prix front left turn signal went out, I replaced the bulb and the light comes on but the turn signal still doesn't work. If I have the lights sent on automatic the right parking


Hey I literally just today had the same problem, put a new bulb in the light was on but did not blink!!!! SUPER EASY SOLUTION, you simply have the bulb in too far. I gently pulled mine out a tiny bit and it started working fine... guarantee that's all that's happening to you!!!

Jan 25, 2013 | 2005 Pontiac Grand Prix

1 Answer

Headlights wont come on. Running and tail lights fine. Wont come on even if manually put them on. Emerg brake not on, fuse seems fine...


Is neither the high beam nor low beam working? Neither the left side nor the right side for each? Knowing this could help isolate the problem. It could be anything from a simple case of blown headlamp bulbs to a burned-up headlamp switch to a defective Daytime Running Lamp Module. I will say, however that I have seen quite a few problems with the headlamp bulb sockets on several of the GMs.

Jan 22, 2011 | 2005 Buick Century

1 Answer

How to change a front turn light in a 1996 taurus.


Lamps, Parking Front Lamp-Lamp Assembly, Taurus
Removal and Installation
  1. Remove Headlamp (13008) as outlined.
Headlamp Assembly
Removal and Installation
  1. ani_caut.gif WARNING: THE REPLACEABLE HALOGEN HEADLAMP BULB CONTAINS GAS UNDER PRESSURE. THE HALOGEN HEADLAMP BULB MAY SHATTER IF THE GLASS ENVELOPE IS SCRATCHED OR THE HALOGEN HEADLAMP BULB IS DROPPED. HANDLE HALOGEN HEADLAMP BULB CAREFULLY. GRASP HALOGEN HEADLAMP BULB ONLY BY ITS PLASTIC BASE. AVOID TOUCHING GLASS ENVELOPE. KEEP HALOGEN HEADLAMP BULB OUT OF REACH OF CHILDREN.
    Position headlamp switch (11654) and headlamp time delay switch (13736) in the OFF position.
  1. Remove two bolts retaining headlamp (13008) to upper support assembly and loosen pinch bolt. Remove headlamp assembly from vehicle.
  1. Remove park lamp bulb and socket (Sable only) and headlamp bulb and socket from Headlamp Assembly as outlined.


    Headlamp Assembly (Taurus Shown, Sable Similar)


    k24744a.gif
  1. Turn lamp socket and wiring (13410) assembly 1/2 turn counterclockwise and remove from parking lamp (13200) housing.
  1. Remove screw from park/turn signal housing.
  1. Using 1/4 inch drive socket extension and swivel, insert tool through two access holes in upper radiator support. Remove screws from park/turn signal housing.
  1. Remove parking lamp from vehicle.
  1. To install, reverse Removal procedure.


    Front Lamp-Lamp Assembly, Taurus


    k23818a.gif

Nov 19, 2010 | Ford Taurus Cars & Trucks

1 Answer

Replace turn signal bulb


The procedure to replace the REAR turn signal light bulb is as follows:- 1) There are three wing nuts on the inside of the trunk for each tail light. 2) Remove the piece of plastic just inside the trunk where the latch is. 3)Then remove the two thumb screws that the cargo net is attached to and the piece can be pulled up. 4)Them pull the carpeting away from the area where the tail light is located. 5)properly remove the three thumb screws. 6) Keep the bulb handy so you can fit the new bulb as the old bulb is removed out. The procedure to replace the FRONT turn signal is as follows:-- 1) First remove the front headlight assembly.And the bulbs . 2) Open the hood to remove the headlight assembly. 3) Pull the headlamp assembly straight out from the vehicle (moving the headlamp up and down slightly may help to remove it easily). 4) Front turn signal is located below the headlamp assembly (turn/parking lamp on top and the fog lamp is below it). 5) Then turn the bulb socket 1/4 turn counterclockwise to remove it from assembly. 6)Then pull the old bulb from the socket and replace it with a new one. Thanks. you can rate this solution and show your appreciation.

May 21, 2010 | 2005 Pontiac Grand Prix

1 Answer

We have a 2005 Hyundai Sonata and both headlights suddenly stopped working. The fog lights and parking lights work just fine but neither headlight will turn on. Both lights are newer bulbs so I would not...


with or without DRL (day time running lamps)

if without...
since both headlamps have their own fuse I would start by testing the headlamp (low) relay

if however, the high beams do not work either, then you may have a more serious wiring concern


let me know if you need any further assistance

Apr 16, 2010 | 2005 Hyundai Sonata

1 Answer

Headlights do not turn on at the light switch.


manual headlamps

Visual Inspection Chart
Mechanical Electrical
  • Headlamp switch
  • Multifunction switch
  • Central junction box (CJB) fuse:
    • 7 (30A)
    • 30 (15A)
    • 46 (10A)
    • 47 (10A)
  • Circuitry
  • Headlamp bulbs
  • Daytime running lamp (DRL) relay No.1


Autolamps

Visual Inspection Chart Mechanical Electrical
  • Headlamp switch
  • Central junction box (CJB) fuses:
    • 19 (5A)
    • 56 (30A)
  • Circuitry
  • Headlamp bulb
  • Daytime running lamps (DRL) full relay No.1 (if equipped)
  • Vehicle security module
  • Photocell


If autolamp system, Vehicle security module has a headlamp rela inside of it. under left side of dash.

May 26, 2009 | 2002 Ford F250 Super Duty SuperCab

2 Answers

Driver side blinker won't blink


replace the drivers front bulb. There are 2 different elements in the bulb 1 for park lights 1 for directional

May 25, 2009 | 2005 Buick Rendezvous

Not finding what you are looking for?
2005 Nissan Almera 1.5 Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...