Where are the plugs located on my 2006 chevy colorado 4cly

Greg Bernett

• 2993 Answers
• Posted on Sep 03, 2009

SOURCE: how do i change out the knock sensor on a 2006 chevy colorado

You didn't list your engine size so please pick the applicable to your motor size:

Removal & Installation 2.8L & 2.9L Engines To Remove:

1. Lift the vehicle high enough to gain access to the knock sensor (KS) through the left front wheelhouse.
2. Remove the left front wheel and wheelhouse liner.

1. Disconnect the knock sensor (KS) connector.
2. Detach the knock sensor (KS) from the engine block.

1. Attach the knock sensor (KS) to the engine block.
   • Tighten the bolt to 18 ft lbs (25 Nm).
2. Connect the knock sensor (KS) connector.
3. Install the left front wheelhouse liner and wheel.
4. Fully lower the vehicle.

SOURCE: 2006 colorado intermittently fails to start. It

Clean all the electrical connections you can get to under the hood with automotive electronics cleaner,dry with compressed air and pack each connector with di-electric grease.

SOURCE: Where is the radiator drain plug located on the

The drain plug is located on the bottom of the radiator.

Most drain plug ismake of inexpensive nylon/plastic and it may fall apart while you turn it.

The professional method is to loosen the lower radiator clamp and drop to lower radiator hose.

Drain the coolant onto a large drain pan and recycle the coolant.

SOURCE: Transmission fluid for 2005 Chevy Colorado

You would need to find something that is the same as sychromesh fluid that GM uses.

SOURCE: 2006 chevy colorado install brake shoes

how do you replace brake pads