SOURCE: Jeep Cherokee Limited
As you are turning the tailgate is flexing.
If you adjust the striker to get the tailgate to close tighter, it should fix your problem.
SOURCE: My 2000 Grand Jeep Cherokee Cuts Off
Code check is when you have someone put a scanner on it and read computer fault codes. "post" is what you wrote. Crank sensor would be my guess too but with jeep computer systems every good guess is usually wrong!(ignition coil will "break down the same way"
SOURCE: 2000 jeep grand cherokee limited starts in 3rd gear
oil pressure problem should be checked independently of other problems...Use a good accurate mechanical gauge to check. If pressure is good (no less than 15psi at idle hot (I prefer to see at least 20) check dash grounding, block ground and if OK, change sending unit. Dash and body ground can influence operation of shift and body control modules so indirectly your problem may or may not be related, depending upon what you find while testing. And it could turn out to be a defective module! They are expensive and just plugging new ones in may work, but then again, it might not. I might be totally incorrect on this...that's the value of actually being there instead of doing this by "remote control".
If you read the numerous posts pertaining to all vehicles, you will see that you are not alone with electrical problems...As long as the engineers who design this stuff, keep using "modules" to replace ordinary simple and reliable systems, we will continue to have these problems. Do some testing and I'm sure you will find a solution! (I'm still waiting for someone to make a program for a PC that will give a complete readout of every system in a vehicle, including exact faults instead of general system "suggestions")
Good luck
SOURCE: computer light says service 4 wheel drive switch
According to the mechanic who works on my 94 Jeep it's one of three
things:
1) Corrosion on the connector to the switch (which is located
on top of the transfer case).
2) A bad switch. Part cost about $22.00
or,
3) A bad console display. he says they have had a fair number of
console display units fail.
SOURCE: Where is the camshaft sensor located on my 99 Jeep Grand Cherokee
If you still have a cap rotor and ignition wires, it's inside the distributor. If not, it is the part where the distributor used to be (center rear of the engine behind the intake manifold)
89 views
Usually answered in minutes!
×