Question about 1999 BMW 328 Series

Open Question

Battery amp on bmw 328i 2012 - 1999 BMW 328 Series

Posted by Anonymous on

Ad

5 Related Answers

Marc Podeszek

  • 840 Answers

SOURCE: 1998 BMW 328i Rear WIndows broken

then it is the actual buttons for the windows on the rear doors

Posted on Apr 12, 2009

Ad

Anonymous

  • 490 Answers

SOURCE: 2000 BMW 328i yellow oil light on but oil is fine

Your sensor is going bad or you have to change your oil.

Posted on Jul 29, 2009

Ad
ZJLimited

ZJ Limited

  • 17970 Answers

SOURCE: BMW 328i Starter how to replaice

1999 BMW 328I 2.8L EFI DOHC 6cyl

Starter - Removal & Installation

The starter motor on some models is very difficult to see from the top of engine compartment as it is covered by the intake manifold. On these models, without removing the intake manifold, the starter motor must be removed from underneath the vehicle. Because the starter motor mounting bolts are not easy to access, a long extension with a universal joint mounted on a proper sized socket could be used. A three foot transmission extension is commercially available from tool vendors that has a 3 / 8 inch drive of the driven end and 1 / 2 inch drive on the drive end. If used with a non-binding impact universal joint and a proper fitting impact socket, the starter motor fasteners can be removed from underneath the vehicle.
Once the starter motor fasteners are removed, the starter motor may have to be moved side-to-side several times to loosen the dowel pin if it has corroded in place.

NOTE When the battery is disconnected, the radio code, on-board computer and clock settings will be lost. The radio code should be obtained before disconnecting the battery or radio. Once the battery has been reconnected, the radio will not function unless the code is keyed in.
Starter motor electrical terminal fastener torque specifications for all models:
M5 terminal fasteners: 44 inch lbs. (5 Nm)
M6 terminal fasteners: 53 inch lbs. (6 Nm)
M8 terminal fasteners: 115 inch lbs. (13 Nm)
Starter motor mounting fasteners:
Hex head bolts: 36 ft. lbs. (49 Nm)
Torx bolts: 32 ft. lbs. (43 Nm) Starter motor electrical terminal fastener torque specifications for all models:
M5 terminal fasteners: 44 inch lbs. (5 Nm)
M6 terminal fasteners: 53 inch lbs. (6 Nm)
M8 terminal fasteners: 115 inch lbs. (13 Nm) Starter motor mounting fasteners:
Hex head bolts: 36 ft. lbs. (49 Nm)
Torx bolts: 32 ft. lbs. (43 Nm) E36 6-Cylinder Engines
Automatic Transmission Models

  1. Before servicing the vehicle, refer to the Precautions section.
  2. Set the ignition switch to the OFF position.
  3. Disconnect the negative battery cable.
  4. Remove the climate control air intake duct at the rear of the engine compartment as follows:
    1. Release the grille clips at the rear and lift the grille upward from the rubber seal, then remove the seal.
    2. Remove the two self tapping Phillips screws from inside the duct to release the electrical harness housing.
    3. Press the electrical housing downward to expose and remove the two hex head self tapping screws on each side of the duct and lift the duct up and out of the engine compartment.
  5. Remove the intake manifold trim and valve cover trim covers.
  6. Disconnect the ignition coil electrical connectors and ground straps, label for reinstallation and place aside.
  7. Remove the two fasteners that secure the fuel injection electrical connector harness to the rail. Remove the harness and carefully place aside toward the back of the engine compartment behind the right side strut tower.
  8. Remove the intake manifold.
  9. Remove the electrical leads from the starter motor and place aside.
  10. Remove the starter motor mounting fasteners at the transmission bell housing, then remove the two mounting nuts at the L-shaped mounting bracket.
  11. Loosen the L-shaped bracket to engine block mounting bolt slightly, then remove the bolt while supporting the starter motor.
  12. Remove the bracket, then lift the starter motor upward away from the engine.
  13. Visually inspect the starter pinion and ring gears for any signs of damage.
  14. Installation is in reverse order of removal.
Manual Transmission Models
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Set the ignition switch to the OFF position.
  3. Disconnect the negative battery cable.
  4. Raise and safely support the vehicle.
  5. Remove the fasteners for the reinforcement mounted between the frame rails just behind the rear lower control arm bushing brackets. Mark the bar-s direction for proper reinstallation and remove the bar.
  6. Remove the fuel line cover located near the left side rear lower control arm bushing bracket.
  7. Release the fuel lines and reverse light wiring from their routing brackets.
  8. Note the routing of the starter motor electrical wires, remove the wire mounting nuts, and place the wires aside.
  9. Remove the top and bottom starter motor to engine-transmission mounting fasteners.
  10. Remove the two mounting nuts at the L-shaped mounting bracket.
  11. Loosen the L-shaped bracket to engine block mounting bolt slightly, then remove the bolt while supporting the starter motor.
  12. Remove the bracket and carefully lower the starter motor downward away from the engine.
  13. Visually inspect the starter pinion and ring gears for any signs of damage.
  14. Installation is in reverse order of removal.

Fig. A view of the starter motor mounting fasteners and dowel pin. The mounting bolts are threaded into the starter motor

cd45991.jpg

Fig. The starter motor mounting bolts are a different size than the transmission-to-engine mounting bolts

2cbfa11.jpg

I hope help you with this (rated this help) Good luck.

Posted on Sep 22, 2009

Anonymous

  • 1 Answer

SOURCE: 1997 bmw 328i conv.

radio does not work on my 1997 bmw 328 it gives the message
"phone" a mechanic pulled it out of its slot and reset the code...it worked for two days and again it doesnt work with same message

Posted on Sep 10, 2010

TEFLON434

  • 16 Answers

SOURCE: battery was dead . recharged

Battery should be tested to see if it can hold the charge. You may possibly have an alternator problem or other electrical issue.

Posted on Apr 13, 2011

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2011 328I Bmw electric issues after replacing battery


What was the problem before replacing the battery? did you confirm that the battery was bad? What are the "issues" you are having?

Jun 20, 2018 | 2011 BMW 3 Series 328i

1 Answer

I got a p0597 code on my 2012 bmw 328i


That is a code for the electronically controlled engine thermostat. Have checked asap before you do very expensive damage to your engine.

Jul 26, 2016 | 2012 BMW 3 Series 328i Sedan 2.0L 4-cyl....

2 Answers

My 2007 BMW x3 want start all my lights are coming on but it want start


My x3 won't start I need help now!!!): - Bimmerfest - BMW Forums

www.bimmerfest.com > ... > X Series > X3 E83 (2004 - 2010)
Nov 26, 2012 - 10 posts - ‎7 authors I tried driving my 2007 BMW x3 3.0si today and it won't start I don't here a clicking sound and all the lights work and the radio works I tried ... 2007 X3 Won't Start - Battery Shows Full Charge ...
21 posts
May 30, 2014
x3 wont start... charged battery and still died, ideas ...
13 posts
Aug 30, 2013
BMW X3 Doesn't start - Bimmerfest - BMW Forums
25 posts
Jun 25, 2013
BMW X3 3.0 will not start. - Bimmerfest - BMW Forums
12 posts
Feb 7, 2012
More results from www.bimmerfest.com

bmw will not start - YouTube

? 1:14
www.youtube.com/watch?v=s0hzsEyx5us
Jan 22, 2011 - Uploaded by DjJohnny Cruz bmw 325i will not start! ... My 2007 BMW 328i has the identical problem, and it will not start while the ...

Nov 01, 2015 | BMW Cars & Trucks

1 Answer

Where is the fuse for the air pump and what amp for 328i 96 bmw


I do not know of an "Air Pump" for a 1996 328i. Did you mean
fuel pump (15A fuse # 18) or
blower motor (30A fuse # 20)

Sep 07, 2014 | 1996 BMW 328i

1 Answer

Replaced my leaking valve cover on my 328i bmw and the battery is now dead


If its not holding as charge your battery just cvoincidently went bad

Dec 10, 2013 | 2007 BMW 328i Sedan

2 Answers

Where's the battery for a 2008 BMW 328I SA


you should post this in the car forum

Jan 02, 2013 | Cars & Trucks

Not finding what you are looking for?
1999 BMW 328 Series Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

myxelpyxel

Level 2 Expert

43 Answers

gbob59

Level 3 Expert

3063 Answers

old marine
old marine

Level 3 Expert

2310 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...