2006 Mitsubishi Galant Logo

Related Topics:

A
Anonymous Posted on May 19, 2014

How to fix a/c on 2006 mitsubishi Galant for compressor not running when blower speeds on 2-4 Compressor runs when blower speed is on 1 but fan does not blow?

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Jun 19, 2009

SOURCE: 2004 Mitsubishi Galant A/C Light Blinking on Control Switch

Just had same problem with mine. Turned out the condenser was bad.

Ad

svang7

  • 53 Answers
  • Posted on Jul 10, 2009

SOURCE: 2002 Mitsubishi Lancer OZ A/C compressor does not

probably a ground issue...

Joseph Cook

  • 113 Answers
  • Posted on Sep 24, 2009

SOURCE: cooling fans are not running 2001 mitsubishi

Check if your fuse is blown! If not have the wires tested that run into your fan if there ok and show power then your fan needs replaced! Please give me a thumbs up if this helped! Thanks

Anonymous

  • 10319 Answers
  • Posted on May 03, 2010

SOURCE: how do I adjust idle speed on a 2001 mitsubishi

No adjustments are to be made. They simply mount in and connect the wires and drive. If yours is a faulty one replace it

Anonymous

  • 412 Answers
  • Posted on Oct 11, 2010

SOURCE: I have a 2006 Mitsubishi Galant. The 15 amp fuse

Inspect your brake light switch that is located on your brake pedal, these little puppies are notorious for failing on these vehicles, I hope I could help, rate me accordingly, Thanks!!!

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

1991. Why doesn't A/C fan work?

Check the AC fan relay
Symptoms Of A Defective Blower Motor Relay
The blower motor relay's job is to basically bypass the current that passes thru' blower motor resistor and deliver it directly to the blower motor. With the blower motor getting full battery current, it'll run in HI speed.

The most common symptom you'll see, when the blower motor relay fails in your Chevy S10 (GMC S15), is that the blower motor will not run in HI speed (but will run in LO, M1, and M2 speeds).

In some cases, the blower motor will fail and the blower motor will not run in HI but you'll have all of the other speeds working.


https://easyautodiagnostics.com/gm/2.8L/blower-motor-relay-multimeter-test-1

..
0helpful
1answer

2003 jETTA Fan only works high speed. For AC compressor runs but no fan other than when switched to high speed at which time the fan runs at high speed but AC switches off.

a resistor went bad for your blower motor.It is located by the blower motor on a circuit board.You can get the replacement resistor at Radio Shack and solder it in.This fixed my problem
1helpful
1answer

1983 Chevrolet C10 Silverado: The AC compressor and heater blower motor fan will not come on.

The brown wire at the speed switch is the power wire. Powers is then directed to the blower motor resistor throught the orange, lt blue and yellows wires. The blower motor receives power through the orange wire. Check for power at the fuse with the key on. If there is no power the problem could be the ignition switch or the wiring in between the switch and the fuse block

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

3helpful
3answers

The a/c on my 2010 Mercury Milan quits blowing after about 2 hours of driving. Any ideas?

Sounds to me like the A/C clutch is no good and out of adjustment.You should goto your nerrest junkyard and get a used assembly take the clutch off then you learn how it comes off and install it on yours the save the pump for later use if needed. The clutch should only have a .010 air gap after install between th inner elctro magnet and the clutch plate it's self.
0helpful
1answer

A/c only works on low blower speed

Not a VW expert here - but does the fan still blow on higher speeds ?
My first guess would be the fan switch or the resistor.
On most cars the compressor will run with or without the blower, but VW cars may get compressor power from the blower resistor.
3helpful
2answers

04 Saturn vue compressor turns off when fan is set to 3 or 4

The problem is the blower motor speed control resistor, it is located near the blower motor in the housing. I exchanged mine and it works like a charm now.
0helpful
1answer

Car run hot when aircondistion is on high,when i turn air off or down car timp gose down

I think your radiator cooling fan is not coming on when the a/c compressor kicks on. Check the cooling fan relays, low and high speed, and the fan too.
1helpful
1answer

THE A/C BLOWER MOTOR ONLY RUNS ON HIGH SPEED, THE

Blower motor resistor,you need a new 1. It is close to the blower motor in the black casing.
1helpful
1answer

Ac controls quit working blower fan is running on high all thetime. compressor is not working.

fan elays are under hood in black box by battery. 3 of them. 2 for high speed, 1 for low speed. Default is high speed when there is a probem.

Suspect maybe they shorted something out when fixing dent. Did they do any welding on the van? Connecting the cables to the body can sometimes send voltage where it's not wanted.
Not finding what you are looking for?

120 views

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...