Anyone with 2003 with a fuel pressure damper that has an issue!!! Mine has a rubber stopper that was leaking and HAD to be replaced. I was also looking for a helpful answer not to be told to look somewhere else, although looking elsewhere is not a bad idea. The original question was how does it come off. A long 22mm wrench and a LOT of force did not begin to move the item. After clearing the fuel line pressure, I held a dry heat air gun over the rail at the site of the damper for a few minutes. Put the wrench to it and bingo. The new part had anti seize. Replace with new part and the car started right up.
My first question to you would be is why? They hardly ever go bad.
If you're having hard start, or "starving for fuel" conditions I would first run out (down) the majority of fuel in the tank then replace the fuel filter; you run it towards empty so that if you have a tank of bad gas it can cause a motor to behave badly. One you change the filter, put some fresh fuel in. If that doesn't help you should look at the fuel pump; you should have around 42 to 45psi on the out feed side of the pump. Once you have gone through those steps, then start looking at the damper.
SOURCE: locate fuel filter, and safety switch to fuel pump
The filter is located at the rear seat, you have to remove it first, then you will see a cap attach with some screws. Inside that cap you`ll find the fuel filter. Before you change the fuel filter you have to release the fuel pressure first. To do that, first find the FUEL PUMP RELAY in the main fuse box located in the engine. Once you located open the fuel door and take off the cap and leave it open. Start the engine, take off the FUEL PUMP RELAY and leave the engine stop itself, when this occurs turn off the key, the you can take off the filter and changed it
SOURCE: 2003 hyundai elantra gls front wheel stud broke
grab a large punch and hammer and knock out the old broken one. Push the new one in and re tighten. This will pull it into place and because it has splines it should not spin while doing so.
Testimonial: "excellent advice"
SOURCE: Replacing passenger side mirror and casing
you need to remove the trim pannel parallel to the mirror on the inside of the vehicle, normally triangle shaped, from there there will be 3-4 nuts or bolts you need to remove, once that is done the mirror will be free to be removed.
GOOD LUCK
SOURCE: where is the thermostat located in a 2005 hyundai
top radiator hose goes to engine its under that housing
SOURCE: 2001 elantra master power window switch
at the bottom and top of the switch there are retaining tabs. you can try to pop it out at those points with a flathead screw driver, but it is sometimes easier to just remove the door panel to get it out.
323 views
Usually answered in minutes!
See 2003 Elantra answer
×