Question about 2000 Land Rover Discovery

1 Answer

2000 landrover disc. rear signals not working but front signals are can anyone please help

Posted by george rigsby on


1 Answer


  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Land Rover Master
  • 3,709 Answers

Check the rear lighting wire loom from rear of light clusters ,trace the earth wire to the body/chassis connection to ensure a good earth , check for power to the indicater lamp , the bulb holders may be the problem , this is a problem that requires patience as can be hard to trace

Posted on May 08, 2014


Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Rear turn signals not working front ones are working

I would suspect the turn signal switch is defective, that is the most common cause.

Jan 25, 2012 | 2000 Mazda MPV

1 Answer

Rear turn signal and hazard light don't flash (left side only)

The rear left turn signal bulb must be replaced immediatly before it melts the light socket, if it has'nt yet. Also please verify that the correct light bulb is being installed. because even though many bulbs look the same they are not identical. Installing the wrong bulb can be the begining of many, many problems in the particular circuit

Mar 26, 2010 | 2000 Ford Focus

4 Answers

Brake light, Turn signal not working rear right 06' Focus

I have a 2000 ford focus no brake lights. with the brake lights the transmission would not go into drive .replaced the brake light switch checked fuse replaced turn signal switch with no results then i moved onto the wiper switch and replaced it as much to my supp rise it fixed the problems

Jul 26, 2009 | 2000 Ford Focus

1 Answer

The turn signals do not work on 2000 nissan exterra.Fuse was blown. Replaced and blew again after a few seconds.

1.Remove front & Rear turn signal Bulbs.
2.Replace Fuse.
3.Signal on.
4.Fix rear Signal Bulb.
5.Fix Front Signal Bulb.
7.If your Fuse blown.
8.Defect is There.

Jun 11, 2009 | 2000 Nissan Xterra

1 Answer

I have a 2000 Corvette with a turn signal problem. The right front and rear turn signals work fine. The left rear turn signal works but the left from turn signal and runnign light do not. Also, where is...

under the dash on the drivers side should be the other one... as that is a fiberglass body... check all the grounds on the offending lights to make sure they are making contact


Please take a moment to rate this solution thanks

Jan 26, 2009 | 2000 Chevrolet Corvette

1 Answer

2002 ford tarus right signal and break light does not work

Pull the light back out, turn the turn signal on, take a test light, ground it. stick down into the connector. A lot of times, the little metal tabs on the bottom don't make contact and it will cause this problem. Somtimes, you have to replace the connector. Also, if the front light blinks fast, check the bulb in that one - it could be shorted. Hope this helps. Phil

Jan 07, 2009 | 2000 Pontiac Sunfire

1 Answer

Passat 2000 turn signal problem

sound like you have a poor earth on the rear lights or indicator circuit

Oct 22, 2008 | 2002 Volkswagen Passat

Not finding what you are looking for?
Cars & Trucks Logo

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers


Level 3 Expert

85239 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides