Question about 2000 Chevrolet Silverado 2500

Open Question

I have a 2000 chev 2500 ext 4wd and my power mirrors dont work. I checked the fuses and replaced one and now both the mirrors will only go to the left. They will not go up or down or to the right

Posted by Anonymous on

Ad

5 Related Answers

Anonymous

  • 19 Answers

SOURCE: on my 1999 chev silverado the power mirrors and my

check fuses & switches

Posted on Mar 07, 2009


savdragon

Brett Spencer

  • 37 Answers

SOURCE: 2000 ABS relay location

Unfortunately the ABS relay is built into the EBCM. Electronic Brake Control Module. That is located on the frame rail, left side of vehicle and sits on top of the pump. Both parts are likely to be replaced together as getting the module off the pump can be difficult. I recommend a repair facility do this job but it can be done at home. You will likely need to take loose metal brake lines and that can be quite a task also.
Are you getting a code for the relay / EBCM?

Good luck
Please rate my answers if they helped.
Brett

Posted on Mar 20, 2009

Ad

John P Schwantes Jr

  • 1509 Answers

SOURCE: 1996 Chev Silverado K3500 dually, no brake lights

The chevys with red brake lights and turn signals do two things and I've fixeds alot of them. Looking at the tail lights with the hazard flashers on. both sides flash with nothingeles on? Or are the hazards yellow? if they're red and the third eye does work the turn signal switch is possible problem but it doesn't let the blubs and the circuit boards in the taillights out as they can fail and do some really bad stories the wires for the brakes and the turns and the hazards are the same ones and if the turns look right and the hazards look right then the turn signal switch transmites the turn too as this doesn't work part of your story can't be true

Posted on Aug 19, 2009

Mike258

Justin Case

  • 1498 Answers

SOURCE: 2004 chev silverado ext cab. No Power steering

Hi Hollings,

You description was very good, I need to ask for a specific.

When you turn to the left, the wheel is stiff like the engine is off or does it turn smoothly but the vehicle doesn't turn or seem to respond.

I'm trying to rule out broken mounts,

Also, if the wheel is all the way to the right, is it difficult turning back to the left the whole way, or half way. See where I'm going.?

Please comment back your findings

Best regards
Mike

Posted on Sep 07, 2009

Anonymous

  • 1 Answer

SOURCE: power locks and power mirrors dont work from the

I am currently having the same problem with my 2004 Blazer, after a little research I am going to try replacing the engine compartment fuse *** suggested. I will let you know if tis works.

Posted on Dec 26, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 silverado 2500 service 4wd light comes on


problem in the transfercase shift control module.but let dealership check it out since 4WD complex system work on.need diagnostic equipment to troubleshoot.

May 11, 2013 | Cars & Trucks

1 Answer

2000 Chev 4x4 2500; When I try to switch from 2wd to 4wd, the switch wont work. The 4wd does work, but its having a hard time switching.


either the encoder is bad or the complete encoder motor assembly. this motor and encoder is mounted on the left side of the transfer case. easy to change.
this is the most common problem with the gm electronic transfer case.

Mar 06, 2011 | 2001 Chevrolet Silverado 2500HD

2 Answers

Power locks and power mirrors dont work from the controls on the inside of the cab checked the all fuses all were good. the keyless entry remote locks the vehicle from outside but lock switch on both...


I am currently having the same problem with my 2004 Blazer, after a little research I am going to try replacing the engine compartment fuse *** suggested. I will let you know if tis works.

Dec 24, 2009 | 2000 Chevrolet Blazer

1 Answer

I lost my head lights, dome light, horn door


sounds like you have a bad ground somewhere. Check every ground strap that you can find, make sure it's tight, and not corroded, etc. Sounds like the accessories are trying to find a ground, and going through the brake light to do so, thus burning out from too much current.

Oct 20, 2009 | 2000 Chevrolet Silverado

1 Answer

Electrical


check for a good ground connection

Jun 02, 2009 | 2000 Ford Windstar

1 Answer

Need control arms for 1997 2500 RAM 4x4 Diesel


new: www.rockauto.com
used: www.car-parts.com

Dec 18, 2008 | 1999 Dodge Ram 2500 4WD

1 Answer

2000 Chev 2500 Silverado horn replacement


you have a short circuit in the line you must check it

Sep 15, 2008 | 2000 Chevrolet 2500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

john h

Level 3 Expert

23590 Answers

Joe Taylor
Joe Taylor

Level 3 Expert

2228 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...