What is the tire pressure for a 2007 Chevrolet malibu
SOURCE: tire pressure
Seance the car manufactures most likely did not produce the tires that are on the vehicle they will only give there recommendations as to the correct tire pressure. Always look around the perimeter of the tire and it will tell you the proper pressure for that tire. hope this helps. Good luck.
SOURCE: i need to know can i use a 1999 fan blower relay switch in a 2000
I,m sure you can, do they look the same?
SOURCE: How do i turn off the tire pressure light in 2007 chevy impala?
MAYBE THE TIRES R FINE BUT THE SENSORS INSIDE TIRES R NOT EACH TIRE HAS ITS OWN SENSOR WHEN ONE GOES OUT THE LIGHT COMES ON
SOURCE: 2004 Chevrolet Impala tire pressure light guage
1. turn the ifnition to ACC or ON and turn the radio off
2. press and hold the DISP button on the radio for at least five seconds until SETTINGS is displayed
3. press the SEEK up or down arrow to scroll through the main menu
4. Scroll until TIRE MON appears on the display
5.press the PREV or NEXT button to enter the submenu. RESET will be displayed.
6. press the DISP button to reset. A chime will be heard to verify the new setting and DONE will be displayed for one second.
7.Once the monitor has been reset, scroll until EXIT appears on the display
8.Press the DISP button to exit programming. A chime will be heard to verify exit.
The system completes the calibration process during driving
This only works if you have a RDS system on the radio.
SOURCE: NEED 2007 CHEVY MALIBU RADIO CODE
I just got the code for my radio by calling 1-800-537-5140 and choosing the option for my vehicle make. 1 for chevrolet. then i entered 106010 for the customer # and then entered my serial # from the stereo and it gave me a lock code for free. Now i am just trying to figure out how to enter it since my manual tells me to take it to the dealership. Now that you have your 4 to 6 digit code, you can enter it by following the these steps. 1. Make sure your ignition is in the "on" position, but no started. 2. Press/Hold the "HR" button to set the first 2 or 3 numbers. 3. Press/Hold the "Min" button to set the next 2/3 numbers. 4. Press the AM/FM button one time. "SEC" should be displayed. You can now turn the radio on. Good luck!
198 views
Usually answered in minutes!
Michelin recomends 32 psi all tires, you might be having a sensor problem which might be able to be re= programmed, all my best, Gary
I have used 30 psi since I bought the car and have had no problems
The sidewall of all DOT rated tired have the max cold pressure embossed into the rubber. Most tire manufactures consider 15% less of max pressure a low tire. 32 PSI has a softer ride but max pressure gives the best MPG.
×