Where is the transmission range sensor on my 98 honda accord

That could be just a "soft" code. Does it run hot or any other odd acts? Any other codes? If not clear code & see if it returns. It does have a trans sensor but it's a one in a million.

P1456 Honda Evaporative Emissions Control System Leakage Fuel Tank


How to Test Transmission Range Switch Honda 2 2L 2 3L

The two codes are unrelated. For the p1456 code, try tightening the gas cap.
For code p0705 (transmission Range Switch), review the info from the second link.

http://www.driveaccord.net/forums/attachment.php?attachmentid=7049&d=1169840715

Error Code: P0706
Fault Location:
Transmission Range (TR) Sensor - Range/Performance Problem
Possible Cause:
Malfunction Indicator Lamp (MIL) Triggered on first occurrence.
Wiring open or short to ground.
Transmission range (TR) sensor.

where do i change my fuse or light volve in honda accord 1999 signal light don't work

Likely a bad transmission range sensor

P0705 Transmission Range Sensor Circuit malfunction (PRNDL Input). It means something is wrong this sensor, take your car to a Transmission Shop to further diagnose the problem.

i'm sorry i'm not familiar with your vehicle, but a general answer would be either on your shifter assembly, which you'd have to remove the center console trim to access, OR on your transmission near the shifter linkage.

put a manual gearbox in and be a man

check the fuse for the gauges and if not check speed sensor

6
Accord Civic CRV CRX Del Sol Odyssey Prelude
85-98 86-98 97-98 85-91 93-97 95-98 85-98 ECT Sensor (Engine Coolant Temperature)
defective circuit or unplugged / defective sensor
10
Accord Civic CRV CRX Del Sol Odyssey Prelude
85-98 86-98 97-98 85-91 93-97 95-98 85-98 IAT Sensor (Intake Air Temperature)
defective circuit or unplugged / defective sensor
16
Accord Civic CRV CRX Del Sol Odyssey Prelude
90-95 88-95 n/a 88-91 93-95 95 88-95 Fuel Injector System
defective circuit or unplugged / defective fuel injector

check your wiring for dirty connections or broken wires, you may have wires that are rubbed through or connectors that are not making full contact. you will need an ohm meter and check wires for continuity. a wiring diagram will be needed.