What is drive axel nut size of Dawoo leganza 2000?

remove road wheel . remove axle nut , uncouple lower strut and pull disc housing out wards may have to tap axle. the axle is held in the diff housing with a c clip but come out with a sharp pull.

Measure it with a metric ruler from one side of nut to the other. It will be in millimeters, anywhere from 27mm to 32mm, most likely.

typically they are a 35 or 36 mm

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

if you need to remove the axle from the spindle side then you need to take the axle nut off which you have to remove the rim n tire and it will be dead center approx 1in size nut or bigger not sure exact size

second have to remove the nut on the lower ball joint n seperate the lower control arm and strut. will need a ball joint fork which you can get at any parts store and a pry bar to push down on control arm once ball joint is broken loose to seperate the strut. this will allow you to push the axle back troungh the spindle to remove it.

last but not least where the axel goes in to the transmission you will need a small pry bar to pop it out from transmission. jus put it between axle n transmission and apply pressure till it comes out. the axel has a oring style clip which holds it in place so not able to pull it out by hand. caution when you pull the axel it will leak out some fluid so make sure you have a drain pan .

to install jus follow the process backward jus make sure the axel pops back in place securely other wise when you go to drive it you risk it poping out. good luck n hope this helps you

need to now the vehicle 1st 2002 what?

Daewoo tacuma wont hold on rev making tank noise

[Yes] it could be a fuse,have you checked them.

the temp gauge sender unit on single cam is near no1 injector in inlet manifold.
on twin cam engines it under neath inlet manifold in head

plug1 = coil 1
plug2 = coil 4
plug3 = coil 3
plug4 = coil 2

try the code 1325 and see if it will unlock the radio