What dose a shorted dump coil LF mean

C1201 ABS Inlet Valve Coil LF Circuit Short To Ground.

The reason of Citroen C1 C1201 OBD-II Engine Error Code is C1201 ABS Inlet Valve Coil LF Circuit Short To Ground.

Solution: Disconnected, dirty or fouled spark plugs are common causes for engines that won't start. Spark plugs typically need to be replaced every season. You should also check that the spark plug gap is set properly. If your spark plugs look good, problems with your ignition system can also preventing a spark. These can range from a faulty spark plug lead, shorted kill switch or flywheel key damage.

I do not understand what you mean try to compose it better pleas.

Does the truck run? Are you getting spark? If not, you've probably answered your own question. You only have one coil - if it's shorted, replace the coil.

wonder if the spark plug is shorted (bad)? or something wrong with the spark plug wire.

P1401 Differential Press Feedback EGR Circuit High Input
Your EGR port is plugged. Replace your EGR valve, and clean the ports
A code P0302 may mean that one or more of the following has happened:

• Faulty spark plug or wire
• Faulty coil (pack)
• Faulty oxygen sensor(s)
• Faulty fuel injector
• Burned exhaust valve
• Faulty catalytic converter(s)
• Running out of fuel
• Poor compression
• Defective computer
• A code P0305 may mean that one or more of the following has happened:
  
  • Faulty spark plug or wire
  • Faulty coil (pack)
  • Faulty oxygen sensor(s)
  • Faulty fuel injector
  • Burned exhaust valve
  • Faulty catalytic converter(s)
  • Running out of fuel
  • Poor compression
  • Defective computer
  • A code P0301 may mean that one or more of the following has happened:
    
    • Faulty spark plug or wire
    • Faulty coil (pack)
    • Faulty oxygen sensor(s)
    • Faulty fuel injector
    • Burned exhaust valve
    • Faulty catalytic converter(s)
    • Running out of fuel
    • Poor compression
    • Defective computer
    • A code P0302 may mean that one or more of the following has happened:
      
      • Faulty spark plug or wire
      • Faulty coil (pack)
      • Faulty oxygen sensor(s)
      • Faulty fuel injector
      • Burned exhaust valve
      • Faulty catalytic converter(s)
      • Running out of fuel
      • Poor compression
      • Defective computer
      • p1409
      • EGR Vacuum System Leak - Read Our Article on EGR Valve Codes For Help With This Oldsmobile Check Engine Light Code

91 is OBDI not OBDII. The codes are just 12, 34, 45, and 48. 12 - diagnostic mode 34 - MAF/MAP sensor low voltage 45 - Oxygen sensor rich. 48 - not sure on that one What engine do you have? Are there any symptoms? Ill get you some more info once I know what engine.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

A P0301 code means that the the car's computer has detected that one of the engine's cylinders is not firing properly. In this case it's cylinder #1.

Symptoms may include:
the engine may be harder to start
the engine may stumble / stumble, and/or hesitate
other symptoms may also be present

A code P0301 may mean that one or more of the following has happened:
Faulty spark plug or wire
Faulty coil (pack)
Faulty oxygen sensor(s)
Faulty fuel injector
Burned exhaust valve
Faulty catalytic converter(s)
Running out of fuel
Poor compression
Defective computer

Possible Solutions:
If there are no symptoms, the simplest thing to do is to reset the code and see if it comes back.

If there are symptoms such as the engine is stumbling or hesitating, check all wiring and connectors that lead to the cylinders (i.e. spark plugs). Depending on how long the ignition components have been in the car, it may be a good idea to replace them as part of your regular maintenance schedule. I would suggest spark plugs, spark plug wires, distributor cap, and rotor (if applicable). Otherwise, check the coils (a.k.a. coil packs). In some cases, the catalytic converter has gone bad. If you smell rotten eggs in the exhaust, your cat converter needs to be replaced. I've also heard in other cases the problems were faulty fuel injectors.

Hope helps.

which engine light? The Check engine light (yellow) or the Red engine light?

Flashing yellow means you are dumping raw fuel into your catalytic converter and will ruin the $800 cat very quick. It means you have cylinders not firing. Go to Autozone and get the fault codes to see what the cause is.

A flashing check engine light is a critical indicator. That usually means that something went wrong that will damage the emission control system... and that is usually an ignition issue. First off, the OEM plug your car calls for is an NGK irridium... NOT BOSCH and not anything with more than 1 prong. Those NGKs are like 2 bucks and they are the proper plug. Make sure you have these plugs and make sure they are gapped to .028. Next, my suggestion is put all the new stuff on again. Drive it to autozone and have them delete all the codes. Drive it around until the check engine light comes on again, then immediately go back and read the codes. The ECU is smart enough to know which cylinder is misfiring. On these cars, I think they have three banks of two... meaning one "coil" inside the coil pack operates two of the cylinders. So if you get multiple misfires, it's the coil. If you get one misfire it's probably an individual plug wire or plug. Good luck.