How to replace fog light assembly?
Best Manuals
for better result of your problem visit this site
SOURCE: 2006 mercury mariner. stupid tail light assembly.
they are hard to take off sometimes, you are doing it right just keep willing it it will come off, there is 2 gromits that hold it into place might have a little dirt into the plunger.
SOURCE: cd player says bad disc
Before you go and spend all that hard earn money, buy a CD player cleaner at Radio Shack, or The Source if your in Canada.
I believe there in the clearance bin most of the time for $4.99 if it's your lucky day.
Good luck and hope this helps.
SOURCE: In 97 mercury mountaineer, how to turn off "check engine" light
Go to the local parts store, have them check the codes (they will do this for free usually). It will tell you what sensor needs to be checked/replaced. Once the part is replaced, it will clear on its own. They can also reset the code, but it will come back if the trouble persists.
SOURCE: Where is the fuel filter located at on a 2006 Mercury Mountaineer
it should be on the inside of the frame rail
SOURCE: reset the change oil light on 2006 mercury
On the console, where the oil change light is on, scroll through the items until you get to oil life. Once at oil life, hold the reset button and it will say Engine oil new. Press reset again and this should set you oil life back to 100% .
Exploded view of the rear light assembly used on the Explorer/Mountaineer models
The Explorer/Mountaineer models only use two upper lens retaining screws, the bottom use barbed push pins
Pull the lens assembly out from the vehicle body to access the bulb sockets
Grasp the bulb socket then twist and pull it out of the lens assembly
Remove the bulb from the socket by pulling it straight out
To install:
447 views
Usually answered in minutes!
×