How to tufn off drl 2002 corvette z06 - 2002 Chevrolet Corvette

Think last time I did one of them I went in thru ram air intake near light...not sure on yr/model...but I managed to get a new one installed that way after wasting 20 min going other routes

It's possible that you have a dirty mass airflow sensor or an air leak at the manifold. P0102 refers to a lean fuel condition. Jake

Noise when? Going over bumps? When turning? More info needed

Did you put a new battery in the remote, or a new battery in the car itself? Sounds like you lost the program for the key. This link may help. It is for a Malibu, but I can't see as how it would be different.

http://answers.yahoo.com/question/index?qid=20120430065805AAin7Zz

It just unbolts from the body.

You need to have the correct pressure, Key on engine off the fuel pressure should be at 55psi to 62psi.Also inorder for the fuel pump to turn on the cranksensor must beable to produce the proper signal for the fuel pump to turn on,

85-100ft/lb

It's called a "tamper proof TORX" bit

Hello mikemcgee63, my name is JShreader. Thank you for choosing fixya.com.

The Torque Specs for the Thermostat Housing are 10 Nm (89 inch lbs.).

I hope this helps you. If you have any more questions or need any more diagrams, please don't hesitate to ask...Thanks again, JShreader!

About that Vette you are going to see on Saturday, check the trans oil. Look for anything unusual in the color. Smell it and see if you detect any strange odor like a burnt smell. Also, check the engine oil carefully, too. Look at the brake pedal very closely. It can tell you a lot about how the drive operated the car. Was he ******* the brake? Look closely at the lower part of the quarter panels and see if there is any damage like large nicks or dents. Take a look at the radiator front - is it clean without any damage? These are some of the areas you can check to get a better idea of the condition and use of the car.