SOURCE: car misfires 1995 chrysler labaron convertible runs rough
yes to plugs can cause the engine to misfire mostly when the engine is under a load, like going up a hill and u give it a little more gas, at a some what low speed. if it has been a good while and many miles sence the plugs where changed, either way change them! they don't last as they are advertised to. also their are many other things that cause misfires, just a few ( ignition coils,plug wires, dirty fuel injectors, dirty flue filters, flue pump going bad ) these are just a few possibility's that would be the most inexpensive to deal with.good luck to u.
SOURCE: I have a 1995 chrysler labaron convertible can't
If it is truly a factory alarm and not a aftermarket dealer installed one, then you should be able to insert the key into driver door and first lock, and then unlock the car which should disable the system. I am guessing that the key chain remote is either damaged or has a dead battery?
If that does not work you can also try the lock-unlock sequence on the passenger side. There is a sensor switch on the latch inside the door which should reset the alarm.
SOURCE: how do you remove the rear seat in a chrysler 300M
Grab the bottom seat cushion at the front of one side and pull it straight up then do the same on the other side. (you will have to pull up very hard) The bottom of the seat clips in. once you have the bottom out take the 2 bolts out of the seat belt fasteners that holds the bottom of the top seat cushion. Then pull straight up on the seat cushion to slide it off two tabs that hold the top.
SOURCE: need to know engine size
Check the VIN number of your vehicle (Little metal tag on the dashboard in the bottom corner of the windshield on the drivers side). The 8th digit from the left is your engine code. i.e. xxxxxxxExxxxx
If it is E, you have a 2.2L Turbo
If it is D, you have a 2.2L non-Turbo
If it is K, you have a 2.5L non-Turbo
49 views
Usually answered in minutes!
×