I put a push button start and kill switch in the truck and I have gotten it to start two times but now I cant get anything at all
SOURCE: 2000 jimmy stuck in auto 4 wheel drive
when can you engaged auto 4wheel drive and how long can you run it
SOURCE: how to put on ignition switch on a '88 mazda b2200
If you mean actually replacing the ignition switch on the vehicle with a locking column. You need to do this. Dicconnect the battery, remove the lower panel of the dash if there is any. There is a bolt on the steering column near the fire wall on most vehicles, remove this bolt, it will release the spline on the steering column. Disconnect all wiring going to the column, unbolt the column from the dash support. Remove the column from the truck, on the ignition switch you will see where the two shear bolts screw the assembly together, center punch the center of each bolt. Now drill the bolt with a 1/8" drill about 1/4" to 3/8" deep. Now use a 3/8" drill and drill out the shear head until it comes off the bolt. You can now remove the switch assembly from the column. The new assembly should come with new shear off bolts so when you bolt it in place when tightned they will break off rendering it tamperproof again. Most vehicles are designed like this now to stop theft. Check the column for operation before reinstalling it in the reverse of above. You just want to make sure the key locks and unlocks the column before reinstalling in the vehicle. You may want to do this before you totally tighten the bolts and break them off permanently. Good luck, RAC
SOURCE: 1995 dodge ram v8 it has a kill switch i have to
can not find gas kill switch for 1996 dodge ram 1500
SOURCE: everything has power when i
Have a look at this:
http://www.fixya.com/cars/r5605161-trouble_shooting_isuzu_starter
SOURCE: my 85 chevy truck idles real high when you first
thats the electric choke. It warms up the engine so that it will idle properly. It may be sticking. Personally i hate the things and just remove and just hold my foot on the gas a bit when cold starting.
But check and see that the solenoid is not sticking and that the other valves on the carb are not sticking some wd-40 should help.
165 views
Usually answered in minutes!
×