The clutch on my 96 sunfire seemed good a few days ago. then it started going all the way to the floor by itself. today it wouldnt go into reverse and seemed rough(not grinding) going into forwards. i

There are only a few places air can get in the master cylinder and connections the pipe going to concentric slave the connections to slave or slave itself

Your losing fluid somewhere, it is a hydraulic clutch so this means hydraulic fluid powers it. Bring to transmission shop for repair.

If you need further help, reach me via phone at https://www.6ya.com/expert/frankie_091f536560a54e12

The hydraulic clutch works much like the brake system, there is a master cylinder with a piston and spring that should keep the pedal up.
You may have to take the clutch master cyl off and inspect the internal parts.

Hi, Seems like the alarm has set itself on hence all your problems try to by pass the alarm system or take it to a garage that deals with electrical problems. Please leave me feed back Malcolm Campbell, [email protected] Thanks.

does your car have a hydraulic clutch
just had similar problem on my Jeep had to replace the clutch master cylinder and slave cylinder.
you can bleed some clutch master cylinders removing air in system check fluid level full then bleed master cylinder keeping an eye on fluid levels not to run system dry..

good luck hope this helps (PTL)

I have the same problem few days ago, and still didn't find any solution. Can any one please help?????7

The master cylinder or the slave cylinder have failed. I would check for a clear oil looking leak coming from either the firewall/above the clutch pedal or under the transmission. Either way you would need to replace the master or slave cylinder. Hope this helps!

See if the pedal, itself isn't sticking. Next, see if your pedal operates a cable, linkage, or if it is hydraulic and uses a brake line.
(It sounds like a cable is broken)

pull the boot back on the master and see if it is wet do the same with the slave

sounds like the throtte cable is out of a gide grove. check the cable for out of postion and breakage. let me know what ya find out and if it helps.