Indicators flashing to left in nuetral model.

Hi there., when flashers/indicators work rapidly on the dashboard you should check whether it is the same on the actual bulds. Fadt flashing is usually a sign of a bulb failure somewhere. If everything is functioning ok externally I would consult a competent technician for a diagnosis.

try pushing the hazard light switch again. what you have is the hazard lights in operation ( both sides indicators working) In normal indicator operation power from the flasher unit is directed to which ever side you select but by pressing the hazard light switch the indicator power lights up all lights.

see previous poster, where he begs more quite.
in your case, add a 12vdc beeper to the dash flashing indicators.
if you have 2 indicators, add 2 diodes to the beeper , ask.
the best way is at the flasher, ( 2 diodes and beeper.)
beep minus to ground
beeper plus to 2 cathodes (band) 1N4004 diodes, (ubiquitous part) and the each ANODE to each side of flasher Left and right.
bingo , it makes more noise.

i can do a schematic easy, ask.

Be sure the fuse is in place in the fuse-box.

Also test the relay that controls the turn indicators. Occasionally, the relay itself emits the noise heard while the turn indicator is on.

You could potentially have bad flashers. Try looking up in your manual where your flashers plug in. Either in the fuse panel under the steering wheel or the power distribution block under the hood. Once located try replacing the flashers. The Flasher is sort of like a fuse that automatically completes the circuit giving power to the blinker then interrupts the current. It allows the circuit to alternate like this making the indicators flash on and off. You might look at the turn signal fuses while your at it.

check engine bay fuse 12 and fuse 11 in car
ones for hazzard lights so do they work?
the other for indicators(turn signals)
left hand drive has fuse & relays left kick pannel area and right hand drive vehicles are similar
unit is not shown in workshop manuals
does indicators flash when locking unlocking vehicle? control is also through keyless entry module

2006 fiat ducato left indicator only flashes a couple of times then stops also the hazard lamps only work on right side

Your flasher unit is defective..Normally it is built into the hazard switch

it could well be the indicator switch that is faulty

The turn signal opperation is through what is called a multifunction switch. i.e. the switch usually does the indicators and the head lights or basically more than just the indicators.

If the indicators when they are on are flashing, then its not the flasher unit itself for sure but more likely to be a problem with the contacts and wear in the multifuction switch on the steering column.