SOURCE: 1990 oldsmobile cutlas calais 3.3L runs fine in park and neutral
Torque converter clutch is stuck on. Need to visit transmission shop unless you are experienced with internal transmission repairs.
SOURCE: Locating the shift solinoid on 1991 olds cutlas ciera
it's inside the transmisson you have to remove the oil pan on the transmisson to get to it.
SOURCE: 1987 cutlas ciera 3.3 v6, sputters and idle poorly before dying
locate the ECM under the dash on the right side in the side kick panel, gain access.do not remove it,light tap on it while it runs see it the motor changes.you probably need another ECM.I would have to have more info to help you better.
SOURCE: 89 olds cutlass ciera bogging down when accelerating.
my 89 cutlass did the same thing....She would bog down ( when the service engine light came on)....Light would go off and she would run fine...Shop replaced fuel fiter and KNOCK SENSOR, runs great now, the service engine light stays off too. Ran a can of MG injector cleaner thru too.
SOURCE: 1988 Cutlass Calais. Motor runs fine on start up.
Sounds like the veh is loading up on fuel make sure coolant sensor to computer is reading right it could be choking the car.Also check for clean throttle body But what the most likely cause is the mass air flow sensor. Blow it out now do this gently there is a wire in there thats what you want clean. dont spray any liquids on it THANK TIM
51 views
Usually answered in minutes!
×