Question about 2001 Dodge Ram 2500 Truck

1 Answer

Tali light out break light works

All lights wor but passanger side all break lights work

Posted by Brandon Carey on

Ad

1 Answer

Joey Bain

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 109 Answers

Check your fuses and bulbs, just because the brake lights work does not mean your tail lights do, $15 you can replace them all at auto zone

Posted on Apr 18, 2014

Ad

5 Related Answers

Anonymous

  • 163 Answers

SOURCE: when breaking i am only getting light from one

Change the bulb first.

Posted on May 08, 2009

Ad
Molson02536

Harvey N Tawatao

  • 3854 Answers

SOURCE: when I press the break only my passanger side tail

Try replacing the passenger side tail light bulb.
Inside trunk, remove two black plastic nuts holding carpet liner in place on side where bulb is burnt out.
Pull back carpet, use a flat screwdriver to pop out the wiring. Remove three nuts using a small open-ended socket or pliers.
Pop out entire tail light assembly. Locate bulb to be replaced. Rotate 1/4 turn to remove from socket. Replace bulb and repeat in reverse order to reinstall.
Thank you for using fixya and good luck

Posted on Apr 29, 2010

Gale Todd

  • 1116 Answers

SOURCE: Break Light on Passenger Side

Over time corrosion can accumulated and rust out a tail light socket and render it non-functioning. Yes it can be replaced and in your case for about $6.00. You can find these at most any auto parts store.

In case of a problem or clarification or my solution was insufficient, don't hesitate to post me a reply.

If you are satisfied, rate my solution with the "thumbs" or (even better) add a testimonial.

Posted on Jun 08, 2011

Testimonial: "Good Job suggesting the socket. Socket was not energized until I cleaned its contacts. Works fine now! You saved me a lot of money! Thanks Awesome Job"

Nicolo Carlo Parazo

  • 2187 Answers

SOURCE: I have a 1994

This could be a problem with the relay for the turnlight if wiring and terminal connections are OK. If I remember correctly the relays for the light are identical. You can swap them to verify if the relay is the issue.

Posted on Jun 09, 2011

Mr BrokRench

Mr BrokRench

  • 1623 Answers

SOURCE: i have a '92 dakota

Sounds like a bad ground. I would check that first.

Posted on Sep 17, 2011

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Kia Rio. Passanger side taillight doesnt work. Socket tested and is good. No power to just the taillight for some reason. Whats the problem?


I would trace the wiring from the tail light to the fuse box make sure there are no breaks in the wiring it could have cut cut somehow.

Oct 05, 2013 | Cars & Trucks

1 Answer

Heat is cold when it comes out of the driver side but not passanger side


check temp. blend door actuator its what controls the temp doors to change from hot to cold usually pass. side door breaks on jeep grand cherokee's causing pass. side to be cool,have seen some on drivers side break but not as many

Feb 25, 2013 | Chrysler Sebring Cars & Trucks

1 Answer

My passanger side break light will not work......


The light bulb has 2 operations, brake and tail lights. Go to Advance and they will replace it for you.

Feb 18, 2013 | 1999 Chevrolet Malibu

1 Answer

1999 chevy malibu break light not working


Check the wiring itself. Could have a nick in it of loose from the socket itself.

Jan 23, 2013 | 1999 Chevrolet Malibu

1 Answer

Tail light and the tag light will not work


Sounds like a problem in the wiring harness.

Jan 10, 2013 | 2002 Chevrolet TrailBlazer

1 Answer

Passanger and third break light don't work, new bulbs and fuses installed. what should i check next?


I would check the turn signal switch first. The brake lights may go thru the switch depending on the configuration.

Aug 16, 2012 | 1992 Honda Accord

1 Answer

Right rear turn signal and break light one in the same not working replace bulb and still not working. All other lights and functions working the front passanger turn signal work fine. Id there a relay...


Check the new bulb make sure it is a 4157 bulb. If it is the correct bulb, try switching the left and right bulbs to see if the problem is still on the right side. Check the wiring on the right side, look for damaged or disconnected wiring.

Dec 26, 2010 | 2005 Chevrolet Cobalt

1 Answer

When I press the break only my passanger side tail light works. Is this a fuse problem?


Try replacing the passenger side tail light bulb.
Inside trunk, remove two black plastic nuts holding carpet liner in place on side where bulb is burnt out.
Pull back carpet, use a flat screwdriver to pop out the wiring. Remove three nuts using a small open-ended socket or pliers.
Pop out entire tail light assembly. Locate bulb to be replaced. Rotate 1/4 turn to remove from socket. Replace bulb and repeat in reverse order to reinstall.
Thank you for using fixya and good luck

Apr 29, 2010 | 2004 Dodge Stratus

1 Answer

Passanger window problem


this is a new vehicle there is a lock button thats below the controls or above the control make sure its off and not on that can cause this to happen if it is not that then the push button for that window is bad you should be still under warranty take it to dealer if it is that/ Please rate my response thank you very much

Jan 30, 2009 | 2007 Mazda CX-7 Grand Touring

Not finding what you are looking for?
Cars & Trucks Logo

89 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...