Question about 2001 Ford Taurus

2 Answers

How to replace the rear signal light - 2001 Ford Taurus

Posted by Stephanie Beaulieu on

Ad

2 Answers

Dan Burke

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 29 Answers

You need to peel away the carpet covering a few bolts to the rear taillight. After removing nuts, pull the tail light straight out. Remove bulb socket from taillight, and replace bulb.

Posted on Apr 07, 2014

Ad

Jerry Kramer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 3,904 Answers

The whole light assembly comes out and you can remove the bulb assembly from behind. There will be a couple of screws accessible from the trunk compartment behind the concealment panels.

Posted on Apr 07, 2014

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace rear signal light on driver side


Open the rear hatch, remove the screws that hold the rear taillight assembly to the vehicle. Find the socket for the bulb you need to replace and turn it counter clockwise. Remove the socket, then replace the bulb. Installation is the reverse.

Feb 10, 2014 | 2005 Saturn Relay

2 Answers

Tail lights and rear turn signals in 1996 F Bronco stopped working:


Sounds like you lost the ground to the rear lights.

May 31, 2017 | 1996 Ford Bronco

1 Answer

My Turn Led Signal Can Not Blink


The LED lamps are not plug-in replacements for incandescent ones because they place a much lower load on the flasher.

Mar 07, 2017 | 1994 Mercedes-Benz C-Class

1 Answer

Left rear turn signal light replacment


Hello,

To replace the left rear turn signal light, please follow the steps below:
  1. Open the rear hatch of your van.
  2. There are two black button like protrusions behind the hatch next to the turn signal lamp.
  3. Pry these out and remove lens.
  4. Replace bulb.
  5. Then reverse the process th reassemble the hatch back together.
Hope this helped. Thank You for using FixYa!!!

Jan 12, 2011 | 2004 Chrysler Pacifica

1 Answer

I have a 2002 pontiac aztek. My rear right signal/brake lamp does not work. When i signal left, the front and rear left lights flash normally. When i signal right, the front right light flashes normally...


as for the faster flashing thats as simple as a blown bulb, replace the bulb and see if that fixes the problem, it may fix the lot because the other symptoms you mention are a bad connection, if bulb is fine check the connection isnt loose or corroded over. if it is simply file it back to establish better connectivity,

Jun 22, 2010 | 2002 Pontiac Aztek

1 Answer

Rear turn signal and hazard light don't flash (left side only)


The rear left turn signal bulb must be replaced immediatly before it melts the light socket, if it has'nt yet. Also please verify that the correct light bulb is being installed. because even though many bulbs look the same they are not identical. Installing the wrong bulb can be the begining of many, many problems in the particular circuit

Mar 26, 2010 | 2000 Ford Focus

2 Answers

Rear turn signals and brake lights out. Front signals and rear tail lights work fine.


the brake lights and the rear turn signals should be the same bulb check the bulbs to make sure they are not blown does your third brake light work if all brake light are out and the bulbs are good check the brake light switch on the brake pedal

Nov 04, 2009 | 1986 GMC C1500

1 Answer

Right turn signal doesn't work.


the next step and almost certainly the problem is the turn signal switch, have seen this symptom on other years around yours and switch fixed it.

Sep 09, 2009 | 2002 Chevrolet Monte Carlo

1 Answer

1965 ford mustang...rear turn signals, rear emerg flashers & brake lights not working.


Are the rear bulbs OK?
Is the ground good at the rear?are the sockets good?
Are there tail lights and a license plate light?then the ground is OK.
All the things that you say do not work go through the signal light switch....it may need replacing.
First make sure the bulbs and fuses are OK and power is getting to the signal light switch and to the brake light switch.
Nice car!

Aug 31, 2009 | 1965 Ford Mustang

1 Answer

Left rear turn signal and brake light dont work


You have a broken wire to the turn/brake light portion of the light as they use the same wire. Or where the plug goes into the light assy could be bad. Torsion mount lights are horrible and you should think about replacing with a universal light that you can wire direct.

Feb 17, 2009 | 1997 Jeep Wrangler

Not finding what you are looking for?
2001 Ford Taurus Logo

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...