Head bolt torque settings for peugeot 206 1100cc

The torque setting for the nuts on a 1996 Peugeot 306 hatchback will depend on the size of the nuts and the type of bolts they are used with. Here are the recommended torque settings for some of the more common fasteners on the Peugeot 306:

• Wheel nuts: 80-90 Nm
• Engine oil drain plug: 25-30 Nm
• Engine oil filter housing: 25-30 Nm
• Engine oil cooler hose banjo bolts: 25-30 Nm
• Engine oil pump mounting bolts: 25-30 Nm

These torque values are for general reference only and may vary depending on the specific model of the Peugeot 306 and the condition of the fasteners. It is always best to refer to the manufacturer's recommendations for the correct torque settings.

Perhaps you could tell me where the oil filter is situated, Thanks. Sorry I don't know your answer

It is not Torque setting but, 240 degrees is 7 o'clock on clock face.

try asking a service center if you can photo copy the page or use phone take pis of the page. if not try library

Cyl. Head 30 nm 90* 90* new bolts. Big ends 10 nm 130*

Good day i need help with Peugeot partner 1.9 diesel 2005 big eng torque settings

Peugeot 208 wheel bolts (with alloy wheels) should be tightened to 100 NM

@Kenneth Ella: In my Peugeot 206 1.4 (TU engine series), tightening the thermostat housing bolts with a torque 20 nm was the breaking of the thread in the engine head. I think, correct torque is about 10 nm (8-12 nm).

no problem the correct setting is ,hmm it says tighten to 20nm then 40nm and then slacken off 130? and tighten 130? ,well this the proverbial brown stuff from a cow to me as when i do these engine i pull down with a speed key then a rachet then my 80cm snap on bar so i suppose iam pulling down to around 75/80 lbs per inch but in all honesty i never use a torque wrench as i used to torque heads in ford of dagenham at 18yrs old so three engine a minute i just sort of feel for the bolt stretch and that it really .

hallo
If you have normal 1.6 liter 206:
max bolt lenght:176,5mm
20Nm and aditional 240°

1,6 liter 16valve engine
max bolt lenght:122,6mm
20Nm and aditional 260°

Marko