Question about Ford F-350 Super Duty

1 Answer

Fuel in water

I have fuel in water resovor

Posted by john harris on


1 Answer


  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Ford Master
  • 1,121 Answers

Mr. Harris, My advise is to drain the water and fuel mixture from your fuel tank,remove if is easy the fuel tank and completely dry it up,Go by the engine bay and find the fuel pipe which is coming from the tank to the injection system where probably is a fuel filter,renew the fuel filter, blow air in the pipe from the engine side towards the fuel tank-but before you do blow air in the pipe be sure is not connected to the fuel tank,for not sending the water back in. If you did not start the car since water went into fuel,means that you finished with the above,by connecting everything and put fuel in the tank and start the engine. If you did have the engine running when water went into fuel,means that you have to remove the spark plugs and whilst are out and the fuel tank is clean with new fuel and fuel filter make the engine spinning second to second for 2-3 minutes so as the any old fuel to push out from the spark plug holes. After clean your spark plugs or renew them and also before running the engine is good to put an injection cleaner additive in the fuel tank. Better to put fuel up to a quarter of the tank and run it treating all the system.

Posted on Apr 03, 2014


Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

How do I fix my windshield washer?

First do you have water in the resovor? First do you have water in the reservoir?
Can you hear the washer motor working?
If not check for power and ground if ok manually power motor if still not working fit new motor
If motor works check for blocked jets or a hose that has come off.
To clean washer jet find a suitable needle like tool to go inside the jets to clean them.

Aug 05, 2014 | 2006 Dodge Durango SLT

1 Answer

Oil gets into water

head gasket leaking, expensive

Aug 12, 2012 | 1992 Nissan Sentra 4 Door

1 Answer

I replaced my water housing and springs and o rings but it is still over heating. Can you tell me what parts do I need with a radiator fan and what fan do I need? I am confussed but I want a used one as I...

first check two hoses from radiator if same temp. start afew mint. then tach by hand if same tem. or near that means water pump and thero. valve is ok then go to electric sys. check therom. s.w on radiator remove socket connect two line with com.line to check fan ok two speed . if overheating when load this cyl.head gasket need replace. check the smal return hose goes to resovor tank if open littil coolant come out this for breathing coolant back to resovor tank . earler morning you can make sure if cyl.head gasket is ok befor start open the resvor tank cap then start check if there is bubblescomes out .

Jul 16, 2011 | 1992 Volkswagen Cabriolet

2 Answers

2001 vw beetle brake light is flashing at all times. brake fluid is full, pad are ok. What can it be???

Probably low vaccume at servo cracked rubber pipe probbably just check them it's easy enough.

Hope you find the one.

oh! the switch isn't stuck on the fluid resovor is it?

Mar 10, 2010 | 2001 Volkswagen Beetle

1 Answer

My 89 cherokee is over heating badly to ware it dies and it isnt using any water out of th resovor(overflo)

I would start by feeling the top water hose when you first start it, see if the thermostat opens, by seeing if the top hose gets warm. If the thermostat is working, then this sounds like a water pump may be going bad, are there any leaks from the water pump? I hope this helps.

Jul 05, 2009 | 1989 Jeep Cherokee

1 Answer

My Mustang convertable top will not let up or down with the button When i press the button I hear a hummi9ng sound but nothing happens . I checked the resovor behind the seat it is full of fluid any advice...

it sond like its an electric motor and maybe the motor isnt working i have a 99 firebird conv and if it is it shouldnt have any type of resovor

Jun 09, 2009 | 1995 Ford Mustang

1 Answer


All the water goes to the overflow? It could be as simple as a new radiator cap. However you may need to replace the Thermostat your mechanic or local autoparts store can show you where it is. However it also could be a tempature control sensor or a few other Items not always a clear cut solution.

May 30, 2009 | 1999 Kia Sportage

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers


Level 3 Expert

4369 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides