At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Re: How do i replace the heater resistor on 1996 previa...
There will be an electrical connector that is protruding from the blower motor housing. If you disconnect this connector then unbolt the housing then the resistor comes right out.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
on the previa, the main fuse box is located in the top of the dash board, the panel above the heater switches comes off to reveal it. There is a little level/clip just above the heater switches hidden by the curve of the panel, push and lift. Turn the ignition switch to the "Off" position. Insure the component with the suspected blown fuse is turned off. Reach under the central instrument panel cover, located above the air conditioning controls in the center of the dashboard, and press upward on the panel cover release latch. This is where most of the fuses are located in a Toyota Previa. Lift the panel cover up and off. Observe the underside of the control panel cover. It will have a schematic diagram along with the name of each circuit controlled by the corresponding fuse. Determine the location of the fuse that controls the affected component. The Toyota Previa makes use of three different types of fuses: type A, which are thin and elongated, type B fuses that resemble a box with a window in the top to reveal the fuse link, and type C, which also resemble a box with a clear plastic top. Grasp the suspected fuse and pull straight up and out. Look down through the clear top of the fuse. If the metal connector is broken and not connected, the fuse is blown. Insert a replacement fuse of the same type and amperage rating into the vacant slot. Replace the instrument control panel and press down until it snaps closed. Turn the ignition switch to the "On" position. Activate the suspected component. If replacing the fuse did not solve the problem, troubleshoot further or take the car to a qualified technician for repairs.
the last year, your blower resistor has been bad, now your motor is bad. rap on the motor and see if it start to run, if so, replace the motor and the resistor.
Why are you jumping the blower switch? If the issue is the switch is not functioning replace the fan resistor located on the side of the heater box under dash try that first.
not to many local independent repair shop will have the right equipment to test or do correct diagnostic. same way if you have bone problems, you want to go see the bone specialist not an eye doctors, Engine service light could mean one or many things, I would recommend take it to Toyota Dealer and have them do proper diagnostic, Will cost you 70 to 85 bucks, its lot cheaper than guessing and buying parts and hope that will be the right one. Once they do diagnostic they will tell you what it need and you can do the work replacing the part your self. good luck
have the oil pressure checked ... if you are not using too low a viscositity of oil (the weight) you might be able to use a thicker weight oil to raise the pressure.
×