Brakes diagram i need diagram to the rear brake

Does the fuse blow before or after you step on the brake? If it blows only after you step on the brake, and voltage from stop lamp switch only goes to rear brakes and not through multifunction switch. If only one connector at the rear for brake lamps, take connector loose, step on the brake, if the fuse still blows, the problem is before the connector. You could Use new wire from brake switch feed, when brake switch is activated, to the rear brakes. Leave pigtail at both ends, splice in new wire, You could let new wire just lay on the ground, for testing, from brake switch to rear brakes. If the brakes work and doesn't blow the fuse, Make the new wire permanent and route the wire properly. Just my opinion. I don't have wiring diagram for your model year.

front still ok ???? U don't have brake light's on the front of the vehicle .Which brake light's ? center high mounted , right , left ???? All of them don't work ? Fuse - brake lamp switch , rear electronic module . The brake light switch is a input to the rear electronic module ,the rear electronic module turns on the brake lamps .
free wiring diagrams here http://www.bbbind.com/free-tsb Enter vehicle info. , year , make , model an engine size. Under system click on lighting , then under subsystem click on turn signal lamps . Click the search button then the blue link . Look on the right side of the first diagram . See the brake pedal position switch , fuse at the top an rear electronic module at the bottom . Second diagram show's rear electronic control module

There are no brake line diagrams,never have been

A factory service manual may show a partial on some
line,but is of no value as to what you want

You have allthe original factory lines
If they are rusted out ,etc,you copy what
you have & bend,form or change as you see fit.

If you have some type of braking issue or problem
you need to provide details & the question

You want a diagram for the rear back brakes as opposed to the rear front brakes? Just curious....

Here is a diagram of a typical GM rear drum brake system.

Try using a Web search and use Photos for the word Diagram. If you use Diagram, most likely all you will get is a linear Diagram similar to a wiring Diagram and of no use to you.
Drum brakes are easy, just take off the rubber adjuster cover and tweak the STAR wheel to collapse the brakes and make them narrower. Sometimes you may have to loosen the Emergency brake cable because it cantilevers the only brakes you have in the rear wheel. (Unlike a Rotor which has 2 brake systems inside of each rear wheel.)

Follow the brake line starting at the left rear wheel, there is no diagram for brake lines, take the tire off and inspect (look) left rear wheel, It will be wet where the leak is, if the inside of the tire is wet then you might want to check the brake cylinder, behind the brake drum. You might want to take it to a shop and get it fixed, It is your life and others, if you can't stop.

Copy and paste this into your search window: 2002 ford ranger rear brake diagram

You should see four pictures pop up, select the brake parts diagram or the brake picture.

Here is the diagram,It is always a good idea to only disaasemble one side so you can use the other side as a reference,I also reccomend using a set od brake pliers,they will the disassembly and reassembly much easier.

Look at other side rear brake, if you can't transpose it in your mind, then stick a big mirror in front of the other side and take a photo of the brake image in the mirror ... hmmm,  you may end up thinking like this after a while.  I don;t know that that is a good thing;~).
good luck, ..ajm


please rate all solutions

i need a diagram for drum brake assembly 1998 ford taurus se