Lost regular remote entry key
SOURCE: 2005 Pontiac SV6 Montana key fob unlocks doors but will not lock
For the sliding doors you need to clean the contacts, there are 6 or 8 on both sides, just wipe them clean as they are probably covered in oil/grease/grime.
SOURCE: My 1999 pontiac montana rear sliding power door will not work
I went to bulldogsecurity.com and looked up the wiring diagram for this vehcle. However, prior to checking this part, I would check to see if you have a blown fuse. It doesn't hurt and only takes a few minutes. There should be a fuse for that either somewhere on the side of the dash or near the brake pedal area. If not it may be under the hood, but it should be inside the vehicle. You may have multiple fuse boxes. If it has (2) sliding doors it will have a wire for the auto doors in each kick panel (under the plastic trim/molding) when you open the door and look down you will see all of the trim/molding it should snap out or may be held in place with a screw or (2). Once you remove that you should see the wires. It says for the left side it is either light blue or black and the right side is definitely light blue. Trace this wire until you find out where it ends (the motor or switch to control the auto doors) Then test the switch/motor to see if it is bad.
SOURCE: 2003 Montana Remote & Key Programming Help ..
Ignition keys relearn takes about 30 min to do. 30-Minute Learn Procedure 1. Turn ON the ignition, with the engine OFF. 2. Attempt to start the engine, then release the key to ON; the vehicle will not start. 3. Observe the SECURITY tell tale light. After approximately 10 minutes, the light will turn OFF. 4. Turn OFF the ignition switch, and wait 5 seconds. 5. Repeat steps 1 through 4 - two more times - for a total of 3 cycles of 10 minutes. 3x10 = 30 minutes. The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch turn from OFF to CRANK Important: Turn the Ignition Switch OFF. The vehicle learns the Passlock Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle. 6. Start the engine. The vehicle has now learned the Passlock Sensor Data Code and/or password. 7. With a scan tool, clear any DTCs if needed. History DTCs will self clear after 100 ignition cycles. Without a scan tool you may have momentary starter interruptions while history clears itself.
Dec 2009.
I also have a 2006 sv6 witht he exact same problem. The battery diesd in the remote and after changing it only sets off the alarm now instead of starting? Di dyou figure out the problem?
102 views
Usually answered in minutes!
×