No power radio,no door lock, no headlighs - Escape Ford Cars & Trucks

Hello Al,

Does your dash display a flashing "service soon" indicator?
Have you checked for fault codes?

You have a good battery, your ignition switch is powering up the vehicles dash board and the vehicle will start and operate normally....?

Any lights on the radio display?
Check for 12 volts on the radio power lead...no power? check for 12 volts across the accessory / radio position in the fuse box. No power but fuse is good...wiring issue in the harness.

Power across fused circuit no power to radio check radio's in line fuse...fuse good? ... radio bad or disconnected speaker wires.

Make sure all your vehicles grounding positions are clean and tight.

When you say your door locks don't work are your talking about the switch on the door or the remote fob?

Check your owners manual to check for any radio reset info.

#1: Panel Illumination
#2: Guages,Right High beam headlight and the high beam indicator
#3: Rear Wiper, Left headlight High Beam
#4: RH park, backup lights switch and relay,Speed porpotional steering module,power door lock switch illumination and daytime running lights(Canada)
#5: Power Door locks,Power Mirrors,vanity,dome,map,ignition and trunk lights,sunroof,radio,power antenna,body control module and power for the data link connector
#6:Heated mirrors,heated rear window indicator
#7: Instrument cluster illumination,park and tail lights
#8: Cigarette lighter,Radio Amp and horns
#9: Power door lock motors
#10: Not used
#11: Radio
#12:Left low beam head light
#13,14,15,16 not used

Dash lights (Gone?) - FSB Forums - FullSizeBronco.com

www.fullsizebronco.com/forum/21.../198643-dash-lights-gone.html

Sep 7, 2011 - Fully rotating the shaft counterclockwise past a notch activates theinterior lights within the vehicles. ... No aftermarket stereo, the dash lights stopped working, and my taillights ... 8 15 Courtesy/Dome/Cargo Lamps, Electric Outside Mirrors, ... 12 20 C.B. Power Door Locks, Electronic Shift Motor 4WD, Power ...

Radio died, remote system not working, door locks will not work ...

www.topix.com > Chrysler Sebring

Aug 13, 2008 - So what all is not working at this time is: Door locks (with remote it only ... My lights on the dash dim some times and if I hit a bump the radio goes off, ... All the fuses are good, but still no power to the radio, interior lights, push ...

2009 Chrysler Town and Country No Dash instrument cluster lights ...

forum.chryslerminivan.net/.../55281-2009-Chrysler-Town-and-Country-...

Jan 13, 2014 - 10 posts - ‎5 authors

Chevrolet Silverado 1500 Questions - went out to go to work ...

www.cargurus.com > Questions > Chevrolet > Silverado 1500
CarGurusFeb 28, 2014 - No, If new battery or fully charged the truck and radio would work, at least for a little while. ... issues, radio, door chime, power windows and door locks all still not ... The BCM wake-ups are: Door ajar switches Door handle switches Domelamp ... any door is opened and then the power lock switch is pressed.

sounds like your hazard lights are turned on, if not then maybe your alarm playing up or flat battery ,

your radio is shorted to your door lock circuit
take your car to an auto electrician as the repair is complex

replace IC of car door lock... this is a little black box inside the steering wheel cover

If you know for a fact the fuse that powers the dash lights is good, you may have cooked the dimmer switch. I would want to check the fuse for power and then the dimmer switch for the dash lights.

look for another fuse box in or under dash. still sounds like you have a blown fuse. look in owners manual for all fuse box locations,including underhood electrial center. good luck.

You may be able to reset the door lock feature to off you need to do this from the radio .
First turn off the power to the radio by turning off the switch then turn the key to onn or accs push the prev selector button on the radio until the door locks words are on the radio display then push the next button to the right until it tells you that the automatic door locks are off then push same button until it says exit on the display then prev and you are done
Mike