WHERE IS THE CRANKSHAFT LOCATED

See the horizontal marks in the picture, those are the timing marks.
Here are the marks

cant sensor? CAMshaft CRANKshaft Sensor? About what ?

Was not sure what engine size you have so locations for both.

On the 2.4 Engine, it is located behind the timing cover just above the crankshaft gear. To gain access, you will need to remove the timing cover.

On the 3.4, there are two of them. One is located on the side of the engine (facing firewall) near the center of the block. The second sensor is located behind the crankshaft pulleyon the outside of the timing cover and is held in place by two bolts.

Crankshaft Position Sensor Removal & Installation 5.4L & 6.8L Engines To Remove:
Before servicing the vehicle, refer to the precautions in the beginning of this section.

1. Remove or disconnect the following:
   • Battery ground cable
   • Accessory drive belt
   • A/C compressor electrical connector
   • Position A/C compressor aside
   • Crankshaft position sensor electrical connector
   • Bolt and the sensor

To Install:

1. Install or connect the following:
   • CKP sensor torque bolt to 89 in. lbs. (10 Nm)
   • Crankshaft position sensor electrical connector
   • A/C compressor and electrical connector
   • Accessory drive belt
   • Battery ground cable

6.0L Engine To Remove:
Before servicing the vehicle, refer to the precautions in the beginning of this section.

1. Remove or disconnect the following:
   • Battery ground cables.
   • Crankshaft position sensor electrical connector.
   • Bolt and the sensor

To Install:

1. Install or connect the following:
   • CKP sensor torque bolt to 8 ft. lbs. (11 Nm).
   • Crankshaft position sensor electrical connector.
   • Battery ground cable

The 2 crankshaft sensors are located on the front of the engine block, between cylinder Numbers 4 and 6. Crankshaft position A sensor is located on the upper crankcase and crankshaft position B sensor is located in the lower crankcase. Both sensors extend into the crankcase and are sealed into the engine block with O-rings. The crankshaft position sensors are not adjustable.

crankshaft position snsr is located on back of engine block near the tranny housing

front bottom of engine. It's wires connect to module and module is attached to coil packs.

underneath timing belt cover

can u please tell me where on my 2004 chrysler pacifica is the crankshaft sensor located?

7X Crankshaft Position (CKP) Sensor
Lower rear of engine
4
25
--
24X Crankshaft Position (CKP) Sensor
Right hand side of engine, at end of crankshaft, behind harmonic balancer
7X Crankshaft Position (CKP) Sensor
Lower rear of engine
4
25
--
24X Crankshaft Position (CKP) Sensor
Right hand side of engine, at end of crankshaft, behind harmonic balancer
Right hand side of engine, at end of crankshaft, behind harmonic balancer