How do I replace my ignition lock assembly in my 1992 bmw 325i e36?
I heard it was difficult, but can't afford to bring to a shop. I would like to have step by step instructions to replace myself. Do I need special tools or will everthing come apart with screw drivers, socket set, and pliers? Thanks in advance for any help.
BMW ignition lock replacing.
According to manual no special tools needed. here procedure!
Testimonial: "Thank you for your response"
BMW ignition lock replacing.
According to manual no special tools needed. here procedure!
Ignition elec switch. Disconnect battery. 2. remove trimpanel from lower leftside of instrument panel. remove screw retaining lower steering column and remove cove. 3. remove slotted screws on both side of switch. 4. relase tabs and remove switch from elec harnass and remove sealer.. note: before mating new ignition elec switch check that switch is in correct position. seal screws again.
Ignition lock cylinder replacing. 1. insert master key and turn 60 deg to radio position. 2. inset piece of stiff wire into opening in lock cylinder and pull cylinder out. (Note early models up to 10/95 turn lock cylinder back 12 deg to release)
BMW ignition lock replacing.
According to manual no special tools needed. Here”s procedure!
Ignition elec switch. Disconnect battery. 2. remove trimpanel from lower leftside of instrument panel. remove screw retaining lower steering column and remove cove. 3. remove slotted screws on both side of switch. 4. relase tabs and remove switch from elec harnass and remove sealer.. note: before mating new ignition elec switch check that switch is in correct position. seal screws again.
Ignition lock cylinder replacing. 1. insert master key and turn 60 deg to radio position. 2. inset piece of stiff wire into opening in lock cylinder and pull cylinder out. (Note early models up to 10/95 turn lock cylinder back 12 deg to release)
×
1,408 views
Usually answered in minutes!
×