Question about 1996 Chevrolet Blazer

1 Answer

My 1996 s10 chevy blazer stalls out while running even when I am driving, then the battery light pops on, what is the problem?

Posted by TaLi LaMont on

Ad

1 Answer

Raymond Garris

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

  • Contributor
  • 41 Answers

Baty light comes on because its not running the stalling cd several different thangs

Posted on Apr 16, 2014

Ad

3 Related Answers

Anonymous

  • 56 Answers

SOURCE: 98 chevy s10 blazer turn signal

Unplug the turn signal relay from the fuse box and start you engine. Does it still make that noise?
If yes... Put the relay back in, that is not the problem.
If No...Then the relay could be bad, replace it!

PLEASE RATE THIS SOLUTION! Thank You Very Much!

Posted on Nov 25, 2008

Ad
Monster80

Joe Lamb

  • 463 Answers

SOURCE: 2001 chevy s10 blazer abs light stays .

The abs is a add on for the brakes that when the tires come into a skid or slid they wont lock up..Your brakes will still work great with the abs disabled but your brakes will lock up if you push on the brakes hard enough to stop.Mainly abs works in slippery conditions not letting the tires lock up and keep the car rolling instead of making it slide..But no effect of the brakes will happen..Just make sure your fluid is full and there are no leaks and if you want to get them check you can stop by your local Auto Zone and they will scan your car for free and tell you what sensor is bad..I hope this was helpful to you...Have a great night

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589

Posted on Apr 03, 2009

Anonymous

  • 617 Answers

SOURCE: 1991 Chevy S10 Blazer 4.3 4x4

4170636.jpgThis is all I've got.Hope this helps?

Posted on Dec 20, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Schematic for 1996 chevy blazer fuel tank


Get a Haynes or Chiltons Manual for diagrams and instructions for your vehicle.

Sep 13, 2014 | 1996 Chevrolet Blazer

1 Answer

Why does the car stall in my 1996 s10 chevy blazer while running?


A car stalls when the engine receives a sudden massive increase in load (think when you were learning to drive - releasing the clutch too quickly would cause the car to stall by transferring too much friction too quickly from the gearbox to the engine)
If the car only stalls when you are setting out from stationary then better engine/clutch control control is needed, or there is a problem with fuel or clutch. If it is an old car, try putting more choke on when pulling away.
If the car stalls all the time, the general reason is that there is probably either a fuel or an ignition problem causing the engine to cut out. Of course, there could be any number of things wrong with your car if it stalls during normal driving

Mar 10, 2014 | 1996 Chevrolet Blazer

1 Answer

1996 chevy blazer starts and then stops


Its either the fuel pump or the fuel regulator.Fuel pressure sure be 60-66 psi with key on and engine off.

Jan 04, 2012 | 1996 Chevrolet Blazer

1 Answer

I have a 1990 chevy s10 pickup, it stalls in reverse and sputters like crazy when driving. I t idle real rough and I have to drive two footed so it won't stall at lights. It also has problems going up...


you could have a fuel pressure or volume problem that will have to be checked out.could be a plugged fuel filter.it could even be a tune-up problem(bad plugs,wires,etc)its possible that the catalytic converter may be plugged and this will have to be testes with a back pressure test.these are places to start.

Apr 29, 2011 | 1994 Chevrolet S-10 Blazer

3 Answers

1991 Chevy S10 Blazer 4.3 4x4


4170636.jpgThis is all I've got.Hope this helps?

Dec 20, 2009 | 1991 Chevrolet S-10 Blazer

1 Answer

How do I replace the rear wiper on a 1996 Chevy S10 Blazer


pull off the plastic cover on the tait gait. then drill the pop rivits out if not already done. switch the motor and put some self tappers in the place of the rivits. done

Nov 20, 2009 | 1996 Chevrolet Blazer

1 Answer

1991 S10 blazer 4x4 4.3 popping coming from the front


the popping sound is the stabilizer links or the lower control arm bushings you can replace all bushings and both link kits for around 50.00 and the light is prob from the sensor on the transfer case or the front end i would remove and clean with dawn dishwashing liquid and put them back.

Jun 23, 2009 | 1991 Chevrolet S-10 Blazer

1 Answer

1996 Chevy S10 stalls out 3 times before steady start


check for loose or cracked vacuum lines, and/or the rotor. It may not be making consistant contact.

Oct 08, 2008 | 1996 Chevrolet Blazer

Not finding what you are looking for?
1996 Chevrolet Blazer Logo

149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

john h

Level 3 Expert

23504 Answers

Joe Taylor
Joe Taylor

Level 3 Expert

2228 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...