Question about 1991 Honda Accord
My car wont start. it was working fine . i check the starter, the alternator and the battery and there ok. im guessing its the wiring but i cant seem to find out wat wire it is.. please help.. asap..
Posted on Apr 23, 2012
My 1991 honda accord's ignition switch will not stay turned on it turns off by itself
Posted on Mar 14, 2010
Further clarification on the O2 sensor location: It is in the exhaust pipe, under the center of the car, on top of the pipe, just aft of the oil filter.
Posted on Jul 14, 2008
Difficult to describe, but I will give it a try.
Inside the driver's side fender, close to the front of the car, there is a bracket that is held in place by one bolt, but which has a short horizontal bar as part of it which has two large clips encircling two cylinderical devices which have wires clipped into them at the bottoms. The one closest to the front (radiator) is the compressor clutch relay. The other one is the condenser fan relay.
Hope this helps you find it.
Posted on Oct 20, 2009
the blower motor is located behind and under the glove box. its held to the blower housing by three screws. remove the three screws and the motor will slide down and towards you. to test the motor. apply power to the yelllow/black wire and ground to the blue/red wire. the motor should run. if not you prob have a faulty power resistor.
Posted on Mar 17, 2010
Tips for a great answer:
Aug 28, 2014 | 1991 Honda Accord
Jul 24, 2012 | 1991 Honda Accord
May 18, 2010 | 1991 Honda Accord
Oct 14, 2009 | 1991 Honda Accord
Aug 06, 2009 | 1986 Honda Accord
Jul 11, 2009 | 1992 Honda Accord
Jan 29, 2009 | 1991 Honda Accord
Jul 12, 2008 | 1991 Honda Accord
937 people viewed this question
Usually answered in minutes!